Offshoreonly.com - Char lynn helm ID, cant find info.

Page 2 of 2

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Boating Discussion (https://www.offshoreonly.com/forums/general-boating-discussion-51/)

- - Char lynn helm ID, cant find info. (https://www.offshoreonly.com/forums/general-boating-discussion/337567-char-lynn-helm-id-cant-find-info.html)

JMPH	05-22-2016 03:25 PM

Quote:

Originally Posted by vintage chromoly (Post 4441659)

You can index the helm in any direction. It's pressure fed.

Thank you

phragle

05-23-2016 11:42 AM

Im still not finding anything, its like the part number doesnt exist.

96scarab

05-23-2016 12:23 PM

http://www.baileyhydraulics.com/pdf/06-317%20(1).pdf

phragle

05-23-2016 12:32 PM

Quote:

Originally Posted by 96scarab (Post 4442254)

http://www.baileyhydraulics.com/pdf/06-317%20(1).pdf

Its not in there either......

phragle

05-23-2016 04:11 PM

direct from eaton/char lynn They are unable to find any record of that part number.......

buck35

05-23-2016 04:51 PM

Quote:

Originally Posted by phragle (Post 4442330)

direct from eaton/char lynn They are unable to find any record of that part number.......

If its a gear driven positive displacement pump you can open it and count teeth, then you will know for sure exactly what you have, or at the very least they can tell you what you have. At least I would think.

phragle

05-23-2016 05:20 PM

It doesnt even match what is listed as the C dimension to figure out displacement, but ut come close to what should be 95 cc. Taalked to Imco today and gave them my ram part numbers and they said I should be around 3 turns lock to lock so I am just goint to put it together and see what happens.. worse would be swapping helms which would be a direct swap out.

hallj

05-24-2016 07:22 PM

Can you blow through the press port?
Jeff

All times are GMT -5. The time now is 02:38 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page