This is what I made .

Nice looking set-up Strip. What kind of punp is that?

Hey Strip ....also why pump it ? .. I was looking at the kits....60.00 ..for a fitting and a piece of hose ..... Is that a cap on the end ?

here is a pick of my oil drain hose. Have yet to try it out though.

Mag .. you make that ?

well sort of, I had to go to the hardware store to find an adapter to fit my huge drain plug, but I got the hose kit from I think CP Performance, I"ve had it hanging in my shop for a few years and never used it until now.

The pump is a teel you can get it from Granger.You can hook up a water hose to it also.run dry and come with a rebuild kit.

Its sucking it out . It will suck out 10q in less than a Minuit.. I use a 5 gallon bucket ,hook up the clips ,flip the switch and The cap in on the out put some not to drop any.I just wire tie the hose that on the motor by the sea strainer and use the quick connects .I can change both motors in about 30min. Takes longer pouring the oil in it. and no mess.

Shop around on the fitting with the hose .I have found them for around 15.00.Been awhile though,I changed out the hose to the blue areoquip 3/8 fuel hose for looks .The quick connect I get it at a hydraulic hose place for about 10.00 for both in steel . the brass was high.

I can take better pictures since the motors are out if anybody wants???

Why pump it out ? Gives me more time to drink beer

Rob