TRS Outdrive Blue Prints
04-20-2005 | 06:12 AM
#2
Registered
Joined: Jan 2001
Posts: 623
Likes: 2
From: Toledo Ohio Eubank Ky
Re: TRS Outdrive Blue Prints
Dragon V,
I have the shim tools for the upper.I could draw you a hand sketch.
I would also like to have drawings for the lower tools so I could make them.Maybe someone has a set of lower tools that You or I could borrow and reverse engineer.
Rob
I have the shim tools for the upper.I could draw you a hand sketch.
I would also like to have drawings for the lower tools so I could make them.Maybe someone has a set of lower tools that You or I could borrow and reverse engineer.
Rob
01-01-2011 | 12:00 PM
#3
Registered
Joined: Sep 2005
Posts: 37
Likes: 1
TRS Outdrive Blue Prints
recently I had the luck to find a cheap and brand new TRS gear housing.
The gentlemen who sold it owns a lot of special Mercruiser tools and understandably he wants to keep them.
So we measured the dimensions of the TRS gear housing shimming tool (see attached sketch)
Anyway as the accuracy of the micrometer was questionable I would appreciate if somebody could confirm the value of the smaller diameter with 2,213" (56,21 mm).
Large diameter of tool ± 4,3" (109,22 mm) can be machined acc. to measurement of diameter that guides the bearing carrier inside the housing.
Joe
The gentlemen who sold it owns a lot of special Mercruiser tools and understandably he wants to keep them.
So we measured the dimensions of the TRS gear housing shimming tool (see attached sketch)
Anyway as the accuracy of the micrometer was questionable I would appreciate if somebody could confirm the value of the smaller diameter with 2,213" (56,21 mm).
Large diameter of tool ± 4,3" (109,22 mm) can be machined acc. to measurement of diameter that guides the bearing carrier inside the housing.
Joe
