Chirping sound from 496?
#1
Registered
Thread Starter
Join Date: Jun 2002
Location: waterford,mi
Posts: 374
Likes: 0
Received 0 Likes
on
0 Posts
Chirping sound from 496?
Just curious if anyone else has this or knows what it is. Must not be too serious, its been doing it as long as I can remember. Sounds like loud fast cricket chirping, Belt squeal?
I open the hatch when I start it, Its not loud enough to hear when the hatch is closed. Thanks, JC
I open the hatch when I start it, Its not loud enough to hear when the hatch is closed. Thanks, JC
Last edited by fountain27ho496; 06-27-2005 at 10:41 AM.
#3
Rough Seas Lie Ahead
Gold Member
Join Date: Feb 2002
Location: Virginia Beach, VA
Posts: 2,465
Likes: 0
Received 0 Likes
on
0 Posts
Re: Chirping sound from 496?
Yep. I get it out of one of my motors. Sounds almost a like a pulley or a tensioner. Only at idle though, and I can hear it through the hatch until I give it a little throttle for the no-wake.
The other 496HO noise I get is the swoosh suction sound when going from fast idle to standing idle.
The other 496HO noise I get is the swoosh suction sound when going from fast idle to standing idle.
#4
Registered
Join Date: Feb 2005
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Re: Chirping sound from 496?
ok here is what I found from my chirping engine..... lower flywheel housing cover plate, (sheet metal), they are held there with 1/4 in bolts that come loose and fall into the bilge and the plate is rubing against the flywheel, I think the problem is they use a cork gasket on these and the bolts lose Tq. over time and fall out
#5
Rough Seas Lie Ahead
Gold Member
Join Date: Feb 2002
Location: Virginia Beach, VA
Posts: 2,465
Likes: 0
Received 0 Likes
on
0 Posts
Re: Chirping sound from 496?
Interesting. I'll have to closely inspect mine....Don't like the thought of things just falling off motors no matter how insignificant they may be.
#6
Registered
Re: Chirping sound from 496?
Had a chirp on one of my engines. Squirted some wd40 on the belt tensioner bearing to confirm it was the problem. Chirp went away for abourt 30 seconds. Replaced tensioner.
ed
ed
#7
Registered
Thread Starter
Join Date: Jun 2002
Location: waterford,mi
Posts: 374
Likes: 0
Received 0 Likes
on
0 Posts
Re: Chirping sound from 496?
DaveM, 69gps best to date, this year in may full fuel just me. I'll check the belt tensioner and cover plate bolts and report. Thanks for the help guys, the sucking sound is normal. JC
Thread
Thread Starter
Forum
Replies
Last Post
TeamPSI
General Q & A
23
12-10-2007 05:23 PM
dockrocker
General Boating Discussion
8
04-24-2003 07:28 PM