Trim tab limit switch...
#3
VIP Member
VIP Member
Re: Trim tab limit switch...
They make spacers to go into the cylinders,
to prevent them from coming full up.
item # 27 is it.
http://www.mercruiserparts.com/Show_...YDRAULIC+HOSES
to prevent them from coming full up.
item # 27 is it.
http://www.mercruiserparts.com/Show_...YDRAULIC+HOSES
#4
Registered
Join Date: Apr 2005
Location: KENT ISLAND, MARYLAND
Posts: 2,675
Likes: 0
Received 0 Likes
on
0 Posts
Re: Trim tab limit switch...
jay t hate to bust your bubble but thats a zinc and if it were a spacer it would keep the drive from coming down not up sorry!!!!!
#6
Registered
Join Date: Nov 2003
Location: Savannah, GA
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Re: Trim tab limit switch...
They do make a spacer for some drives that will hit the swim platform . I am not sure if your saying you have a bad switch or your drive goes too high. If its the latter you can ad a spacer (not zinks) but a spacer
#7
Offshoreonly Advertiser
Offshoreonly Advertiser
Re: Trim tab limit switch...
Joe, Jay is right, that is the spacer, it just looks like the zinc. It goes inside the cylinder on top of the piston. It's slotted so all you have to do is remove the end cap and slip it in. YOu could also use more than 1 if needed. There are 2 in each kit.
__________________
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
Marc
www.mercruiserparts.com
www.go-fast.com
www.bammarine.com
www.cyborgtransmissions.com
It's not alive -www.BoatStuffExpress.com - temporarily retired
#8
VIP Member
VIP Member
Re: Trim tab limit switch...
Thanks Marc.
Item # 6 is the Zinc annode.
Item # 6 is the Zinc annode.