Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   water pump pulley hits harmonic balancer (https://www.offshoreonly.com/forums/general-q/120324-water-pump-pulley-hits-harmonic-balancer.html)

FloridianSon 01-15-2006 03:57 PM

Re: water pump pulley hits harmonic balancer
 
Yes on mine there is still some shaft left.My thought is the person at the factory that builds the things had a good lunch and had to much vitamin M for desert which can cause any thing from a slite mishap to a full blown FUBAR.I don't know. :drink: I do know that one monkey don't stop no show.James

tggrounds 01-22-2006 11:31 PM

Re: water pump pulley hits harmonic balancer
 
1 Attachment(s)
Do these pulleys and brackets look like they could be right ? For a 454 and what pulley runs the sea pump.

1BIGJIM 01-23-2006 06:55 AM

Re: water pump pulley hits harmonic balancer
 
Mine looks exactly like the setup above. I will tell you from experience that you must take the water pump pulley off if you pull the balancer. I did not realize until I bent the pulley and the shaft on the water pump. :(
The clearence is real close, like mentioned 1/8 of an inch.

tggrounds 01-23-2006 10:06 AM

Re: water pump pulley hits harmonic balancer
 
On yours what pulley runs the sea pump?

1BIGJIM 01-23-2006 12:33 PM

Re: water pump pulley hits harmonic balancer
 
Harmonic balancer.

tggrounds 01-23-2006 12:59 PM

Re: water pump pulley hits harmonic balancer
 
Is it the middle one on the balancer.

Dangerous Dave 01-23-2006 01:21 PM

Re: water pump pulley hits harmonic balancer
 
Is there a specific reason you are not using a crossover instead of the recirc. pump?

tggrounds 01-23-2006 04:40 PM

Re: water pump pulley hits harmonic balancer
 
I was told by the machine shop that it would be more reliable and keep an even temp through out the block. The guy I'm talking about built motor's for Outerlimits. What do you think ?

FloridianSon 01-23-2006 05:19 PM

Re: water pump pulley hits harmonic balancer
 
My .02 double check everything again,if all else fails pull the hub out just enough to get your clearence.Stay away from the Xover in till you put on the blower.Buy you friend at Outerlimits a beer :drink:

Dangerous Dave 01-23-2006 06:01 PM

Re: water pump pulley hits harmonic balancer
 
I see your point about the recirc pump, just don't run too high of a thermostat temp in salt water. Looks like you're putting together a nice piece. I hope you post some pictures when it's done. My good friend has a 24 Pantera he keeps at my place for the winter. I think it's a much more fun ride than my 28 Cigarette. Good luck.


All times are GMT -5. The time now is 03:41 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.