water pump pulley hits harmonic balancer
 

Has any one had to pull the hub on the water pump forward that the water pump pulley bolts up to about 3/8 " to clear the harmonic balance on a 454? This is my first boat and I have been restoring for almost two years It is a 1980 24' pantera. I would like to send a pic and see if some one can fined something wrong with it. I am trying to get it in the water this June put have a lot of other snags.

Thanks Todd

Re: water pump pulley hits harmonic balancer
 

Once on a small block, I found that the balancer was not pushed back onto the crank all the way to the seat. If felt as if it were bottomed but it really wasn't, removed it and checked and found that it was hanging up a little bit. When it bottomed it was fine.

Re: water pump pulley hits harmonic balancer
 

Did that twice. all the parts are new and was told they should work.

Re: water pump pulley hits harmonic balancer
 

GM has long and short snout water pumps, you may have the wrong water pump, or the wp pully may not be the right one.

Re: water pump pulley hits harmonic balancer
 

88fount33,
Make sure you have the correct harmonic balancer for that engine.

Re: water pump pulley hits harmonic balancer
 

do you have a grinder? jes kidn, are you sure you have the correct balancer? there are several different od balancers avail.

Re: water pump pulley hits harmonic balancer
 

It happened to me one time. Luckily, I had a smaller pulley that cleared it fine. Later, I found the original pulley was warped.

Re: water pump pulley hits harmonic balancer
 

Also, if the balancer is in the correct location, it will be extreme close to the timing cover, like less than 1/8 " away.

Re: water pump pulley hits harmonic balancer
 

Yes I did .checked everything that the group has said.talked to marc at bam then used a puller and moved the pully out.No problems.

Re: water pump pulley hits harmonic balancer
 

Was the tit on the center of the hub still going threw the center of the water pump pulley?

Tried to send a pic but picture size was to big.