Bennett Tabs
#1
Registered
Thread Starter
Bennett Tabs
Hey guys I have Bennett trim tabs on my Formula and was wondering if it was possible to put a trim gage on them and how are they mounted?Where would I get a set up from?Any help would be appreciated.
Thanks Nordic95
Thanks Nordic95
#2
Go Big or Go Home
Platinum Member
Join Date: Jun 2005
Location: Kennebunkport, Me.
Posts: 201
Likes: 0
Received 0 Likes
on
0 Posts
Re: Bennett Tabs
yes they make a trim indicator set it requires replacment of one ram cap on each side it has a wire in it that goes to a module in the dash and an led indicator on the dash. you should be able to get them at any marine store
#4
Gold Member
Gold Member
Re: Bennett Tabs
The Bennett trim indicator requires that you disassemble the rams to install a sensor then the installation of the indicator and wires.
Kit is available from Bennett or through most marine stores.
Kit is available from Bennett or through most marine stores.
#6
Registered
Re: Bennett Tabs
I have Bennett LED indicators, I don't like them too much. The back lighting was out on one of them and was not just a bulb to fix. Also the range of the indicators didn't seem to match the range of the tab.
When I painted my engine compartment this year I did not reconnect the sender wires and plan on installing mechanical indicators from Lovorsi this winter.
http://www.livorsi.com/catalog/mecha...CAL_INDICATOR_
When I painted my engine compartment this year I did not reconnect the sender wires and plan on installing mechanical indicators from Lovorsi this winter.
http://www.livorsi.com/catalog/mecha...CAL_INDICATOR_
#8
Re: Bennett Tabs
Definately do NOT get the Bennett LED kit. Its not favorable for our type of boats.
Sonic installs a mechanical setup just like on the K-planes. I would definately go this route. I can't remember, but I had mechanical indicators on my Bennetts on my Sonic. I think the indicator was mounted to a bolt on the part of the tab that the rams attach to. Perhaps someone in the Sonic forum can provide a picture of how this is setup. Most of the 26' Sonics are this way. I believe the 25' Baja Outlaw is often setup this way as well. I don't recommend the Bennett LED indicators. Too man issues.
Brownie above and Fred at www.trickmarine.net would be places I would talk to.
Sonic installs a mechanical setup just like on the K-planes. I would definately go this route. I can't remember, but I had mechanical indicators on my Bennetts on my Sonic. I think the indicator was mounted to a bolt on the part of the tab that the rams attach to. Perhaps someone in the Sonic forum can provide a picture of how this is setup. Most of the 26' Sonics are this way. I believe the 25' Baja Outlaw is often setup this way as well. I don't recommend the Bennett LED indicators. Too man issues.
Brownie above and Fred at www.trickmarine.net would be places I would talk to.