IMCO Extreme to BMAX conversion question
#1
Registered
Thread Starter
Join Date: Jan 2004
Location: Channelview, Texas
Posts: 913
Likes: 0
Received 0 Likes
on
0 Posts
IMCO Extreme to BMAX conversion question
So we've got the BMAX's in - they use a larger U-joint than the IMCO's.
What we thought was a simple process of changing the input shaft (for the extension boxes) isn't gonna happen.
The U-Joint on the BMAX's are larger.
So - Does anyone know of a U-Joint that will work? Should I get a machinist to modify the shafts?
Or just bite the bullet and call IMCO and order new shafts that will fit the BMAX's?
Thanks!!
What we thought was a simple process of changing the input shaft (for the extension boxes) isn't gonna happen.
The U-Joint on the BMAX's are larger.
So - Does anyone know of a U-Joint that will work? Should I get a machinist to modify the shafts?
Or just bite the bullet and call IMCO and order new shafts that will fit the BMAX's?
Thanks!!
#4
Charter Member #601
Charter Member
Re: IMCO Extreme to BMAX conversion question
I have heard of machining a set of lager caps to fit over the smaller ones. I didnt like the idea then and still dont. But that is up to you, just an idea.
I would recommend buying new input shafts.
Dick
I would recommend buying new input shafts.
Dick
#6
Charter Member #601
Charter Member
Re: IMCO Extreme to BMAX conversion question
Originally the Imco shafts were setup for the small units that are found standard Bravos. When the XR/XZ's came out they made one to fit that. Now Merc has metric input shafts and Imco is looking at that issue, but I dont think they have a product for it yet. It has been a while since I discussed that issue with them.
I am not familiar with the Bmax input shaft ujoints. I would assume they are the XR size? But you know what assuming does. A call to Imco would verify.. Talk to Rick.
Dick
I am not familiar with the Bmax input shaft ujoints. I would assume they are the XR size? But you know what assuming does. A call to Imco would verify.. Talk to Rick.
Dick
#8
Registered
Re: IMCO Extreme to BMAX conversion question
In the automotive world they make U joints large on one end and small on the other. Most good driveshaft shop carry them. Mite be a quick fix if you bring in both sizes for them to measure.
Thread
Thread Starter
Forum
Replies
Last Post
Sick Stinger
General Boating Discussion
22
03-23-2008 04:03 PM
txriverrat2001
General Q & A
0
01-15-2007 10:09 AM