|
Re: Fuel Pump Advice Needed:
not off hand. if u call ramco performance ask for allan mckay and refer him to this unit. it flows 500 gph , is 5 micron, and plumbed with -12 orb. replacement element is 20 bucks
|
Re: Fuel Pump Advice Needed:
On their Website, I found the flowmax300 which flows 300gph and at 5 microns but no 500gph. Is it new?
|
Re: Fuel Pump Advice Needed:
no, call and ask for allan.
|
Re: Fuel Pump Advice Needed:
I have roughly 300 hours on the Hp version of the Aeromotives which are supposedly good for 1000hp? 5/8 out of tank to #12 line into Eickert filter/seperators, #12 to pump. #10 out to a fuel log feeding pair 950's, pressure reg keeps pressure at 6.5 and then returns to fuel tank with #8. Also run the Aeromotive controller which cuts down the voltage to pump below 1500 rpm or so. Has been trouble free.
|
Re: Fuel Pump Advice Needed:
You run the same set up I do, Maybe I am OK.
BTW Eickert filter thread ID is .925" Gasket 3.25" |
Re: Fuel Pump Advice Needed:
Originally Posted by 2112
(Post 1992580)
Is there a high flow in line filter for before the pump in size
12AN availble? My aeromotive is size 10AN. I am 12AN up the to pump and 10AN from the pump to the regulator. In a worse case scenario, would you anyone run no filter before the pump to keep flow high? |
Re: Fuel Pump Advice Needed:
To Let You Know Sx Has A New High Flow Filter #41003 That Is A #12 Inlet And Outlet Flows Up To 180 Gph . This Was Develpoed Just For The Long Suction Lines In Marine Applications. This Filter Will Not Starve The Fuel Pump.
|
| All times are GMT -5. The time now is 10:10 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.