|
My 1000 gauge quit working so I am replacing that hole with the monster water pressure gauge, No problems yet with temp or hoses. I just got a really good deal on these Livorsi gauges fifteen total gauges, yellow rims and yellow bezels, twelve-2 5/8, Three-4 1/5 in. 100mph gps speedo, gps puck, recall switch and 2 monster tachs for $760.00
|
Originally Posted by monstaaa
(Post 2382608)
therer is a bung allready on the oil cooler on the back of the engine used for a water pressure sender for the smart craft and computer monitoring.. remove the factory unit and install a 1/4 pipe male,male, female tee.
|
You can always take one of the drain plugs out of the side of the block, one is by the starter, one by the oil adapter. My last boat was done that way. The new boat has a 525 and is rigged up to the header where the drain plug would be. The oil cooler would be pretty easy too.
|
Not on a 496 8.1.. They are closed cooled.. You are thinking of the other BBC that are open cooled systems.. ;) Jamie / Lakeside
|
Originally Posted by DONZI33
(Post 2387952)
Not on a 496 8.1.. They are closed cooled.. You are thinking of the other BBC that are open cooled systems.. ;) Jamie / Lakeside
Scratch the block, but you could use one of the drain plugs off your exhaust. |
My 2003 496 came with the pressure sender mounted on the seawater pump.
http://img.photobucket.com/albums/v6...uto/16Pump.jpg |
[QUOTE=45auto;2388785]My 2003 496 came with the pressure sender mounted on the seawater pump.
QUOTE] Now you didn't pull your engine just to take that picture for me, did you? |
| All times are GMT -5. The time now is 07:07 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.