Engine Install?
06-05-2008 | 03:26 PM
#1
Thread Starter
Registered
Joined: Dec 2000
Posts: 552
Likes: 0
Engine Install?
On the flywheel cover to transom assembly mount what is the order of the washers, spring, spacer on the bolt. I've seen the schematic that shows it but it doesn't show the flywheel cover mount. I need to know the order with relation to the engine mount.
06-05-2008 | 07:09 PM
#2
Registered
Joined: Jun 2004
Posts: 1,949
Likes: 37
From: Omaha, Nebraska. Boat on the Mighty Mo! Longest river in the USA!
Glue the fiber washer on the inner transom plate. Place the "spring" washer inside the fiber once glued in place.
Lower the engine in place. Stick the big washer on the bolt first, then the spacer. This places the head of the bolt up where it's easier to get to. Ths spacer should make contact with the bellhousing motor mount.
Lower the engine in place. Stick the big washer on the bolt first, then the spacer. This places the head of the bolt up where it's easier to get to. Ths spacer should make contact with the bellhousing motor mount.
Thread
Thread Starter
Forum
Replies
Last Post
mlitefan
General Boating Discussion
16
01-13-2005 07:13 AM
timucin
General Q & A
11
09-23-2002 10:26 AM
