Ice Injection
#11
Registered
Join Date: Aug 2005
Location: sint maarten
Posts: 1,491
Likes: 0
Received 0 Likes
on
0 Posts
so... what is the cost perunit for a typical installation start to finish per motor ? i know the specifics of each installation will be fractionally different but pick a specific motor set up and give me a rough idea of the cost, please.
#13
Banned
Hey BIG Daddy give Rudy a call 1-302-367-4962 what motors are ya runnin and wantin to spray ???
#14
Registered
I,m using Valucraft -20 windshield washer fliud in my injection
system. It is 40%meth60%water
Lowers my EGT 300 degrees and raises the torque of each motor 300 foot lbs.
I gotta be easy on the sticks the Turbines will throw the 6 drive right off the back of the boat
system. It is 40%meth60%water
Lowers my EGT 300 degrees and raises the torque of each motor 300 foot lbs.
I gotta be easy on the sticks the Turbines will throw the 6 drive right off the back of the boat
#15
Banned
OUCH
#16
This is the best system on the market in the automotive world. http://www.alkycontrol.com/ I am sure they can make a system of any application and recommend 100% methanol for consistancy.
Last edited by aTX427; 09-06-2008 at 07:34 AM.
#17
After logging 160* at WOT and 84* at idle, I thought about running meth in my two front tanks.
RunninHotRacing158 - how much lower were you AIT's after the meth install?
RunninHotRacing158 - how much lower were you AIT's after the meth install?
#18
Banned
This is the best system on the market in the automotive world. http://www.alkycontrol.com/ I am sure they can make a system of any application and recommend 100% methanol for consistancy.
#19
I could not find anything on Ice Injection and wanted to do a little research on their product. Do you have their website handy? Curious of their failsafe features. I run Alky Control in my car because they have incorporated several unique functions, e.g., a low fluid level warning sensor, a manual low pressure test function, a progressive controller and an LED the shows when the system activation, then changes color when fully pressurized.
#20
Platinum Member
Platinum Member
This is the best system on the market in the automotive world. http://www.alkycontrol.com/ I am sure they can make a system of any application and recommend 100% methanol for consistancy.
Rudy who is the technical brains behind Ice Injection has been successfully building blown Marine and race car power for over 30 years and was up to this challenge.
How to run safely on 93 octane at this level !
There are a few good kits made for the automotive industry and we tried them all for this application.We also found that know one at these companies could give us anything but vague info as to our application.
Doing the math the flow rates etc is not all that difficult if you are so inclined.But there is so much more than that including needed parts that do not come with the car kits involved in making this safe and consistent.
What we have and continue to accomplish with our weekly R&D is to offer a tested and turn key kit set up for Marine applications. We incorporated the best components available, right down to our own intake gaskets needed to run more than a few hrs before failing.
So for the guy that may not have the hundreds of hrs needed to make a car kit work at this level,we have taken the guess work out.
Glen