Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   non stop porpouse (https://www.offshoreonly.com/forums/general-q/209054-non-stop-porpouse.html)

ar300johnson 05-22-2009 07:26 AM

check your bottom. you can spend all summer swapping props. some will be better than others, but the boat will never run right with an uneven bottom. get a long straight edge and check the bottom for hook or rocker. check the bottom on all strakes, not just the very bottom running surface. if your bottom is bad, fixing it will make your boat much better to drive, be faster and burn less fuel. good luck and i hope that you can get your boat running right.

Fixxxer22 05-22-2009 09:18 AM

how do i go oabout fixing a hook? or am i going to need to find a good fiberglass guy?

Panther 05-22-2009 10:07 AM


Originally Posted by Fixxxer22 (Post 2871170)
how do i go oabout fixing a hook? or am i going to need to find a good fiberglass guy?

Depending on how deep it is you can either sand it out or fill it in. I'd find a glass guy unless you're good at it.

RJBBC 05-22-2009 07:57 PM


Originally Posted by Griff (Post 2870369)
I had a 1993 24 Outlaw

454mag/365hp/1.5 ratio--23 Mirage plus--5050rpms=60mph
------ " 420hp------"------23 Mirage plus--5450rpms=66mph
------ " 420hp------"------24 Bravo 1------5200rpms=63mph

prop shaft was about 7-8" below the bottom of boat.

Griff,
Your 24 Bravo 1 stats are interesting. Our 454MAG with 460HP is at 5100RPMs at 68mph in a Checkmate 259 Convincor. I am not sure about the prop shaft distance from the bottom.
Rob

activemike 05-22-2009 08:57 PM

my first boat was a 24 ft baja outlaw with a 502,if my memory is correct i ran a 24 pitch 3 blade prop labed to 25.5 the boat ran 67 mph with little over half trim & had no porpiss as you say. it did chime side to side at top end though.


All times are GMT -5. The time now is 08:18 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.