Intercoolers
#11
Registered

Joined: Sep 2006
Posts: 1,250
Likes: 0
From: Richmond - Ophelia, Va
While you are in there you may want to do a few other things.
Depending on hours and salt vs fresh water the head gaskets should be replaced at a minimum. I like Cometic. While you have the heads off a good valve job/refresh with new springs/retainers would not hurt either.
I found the Whipples to be higher than the 1-3/4" additional height. I talked to Dustin and measured and measured. Thought I had room but they still hit the hatch.
I did all the work and the $2500 per side still sounds high.
God luck with the install...
Depending on hours and salt vs fresh water the head gaskets should be replaced at a minimum. I like Cometic. While you have the heads off a good valve job/refresh with new springs/retainers would not hurt either.
I found the Whipples to be higher than the 1-3/4" additional height. I talked to Dustin and measured and measured. Thought I had room but they still hit the hatch.
I did all the work and the $2500 per side still sounds high.
God luck with the install...
#12
Thread Starter
Registered

Joined: Feb 2006
Posts: 793
Likes: 59
From: Sandusk, OH
While you are in there you may want to do a few other things.
Depending on hours and salt vs fresh water the head gaskets should be replaced at a minimum. I like Cometic. While you have the heads off a good valve job/refresh with new springs/retainers would not hurt either.
I found the Whipples to be higher than the 1-3/4" additional height. I talked to Dustin and measured and measured. Thought I had room but they still hit the hatch.
I did all the work and the $2500 per side still sounds high.
God luck with the install...
Depending on hours and salt vs fresh water the head gaskets should be replaced at a minimum. I like Cometic. While you have the heads off a good valve job/refresh with new springs/retainers would not hurt either.
I found the Whipples to be higher than the 1-3/4" additional height. I talked to Dustin and measured and measured. Thought I had room but they still hit the hatch.
I did all the work and the $2500 per side still sounds high.
God luck with the install...
#13
Registered

Joined: Jul 2007
Posts: 485
Likes: 11
From: St. Louis / LOTO
Wow?! you charge $65/hour? I sure wish you were local! The average rate at LOTO is $85. Even a buddy charged me that in the past. I need to fix that.
#14
Registered
Joined: Jan 2004
Posts: 4,480
Likes: 43
From: Tennessee
Eddie
#15
Registered

Joined: Jul 2007
Posts: 485
Likes: 11
From: St. Louis / LOTO
Not a damn thing wrong with $65/hr..... the minimum I have found at LOTO is 85.... some are over 100, which is just outrageous. Just my $.02 though.



Except I only get $65.00/hr.