Offshoreonly.com - any advice on repatable engine builder in Phila. area

Page 4 of 4

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - any advice on repatable engine builder in Phila. area (https://www.offshoreonly.com/forums/general-q/265798-any-advice-repatable-engine-builder-phila-area.html)

blue thunder

12-02-2011 07:53 AM

Quote:

Originally Posted by TOMMYTHUNDER25 (Post 3551060)

my 96 HP500 carb is down and out,broke roller off of lifter,scorred cylinder,etc.
would like to get a little more out of it but keep it reliable
any advice would be welcomed

Nevermind, I see it now. Hopefully it can be bored and new pistons and whala. If I were you I'd rebuild it as it was or close to it but load a blower on. Then you can always remove the blower if you want and still have a good platform n/a. I know philms engine/boat runs great so if that is rudys work it looks reputable to me.

TOMMYTHUNDER25

12-02-2011 09:22 AM

1996 25' AT w/500hp carb, 340 hours
I got the motor out and stripped down to long block
would like to build it up a little(550-600hp),depends on $$$
I'm just trying to read up on what to do and what not to do.
my wife says I spend too much time on this computer trying to figure it all out
I appreciate all the info/advice you guys have given me so far

R Addiction

12-02-2011 10:42 PM

Tommy, Low hours. We have 530 hours on a stock 502 MAG/MPI. Is your pole barn at your house? Any pictures? I'm looking to build one for our AT. Its been in a HiDri facility in Port Deposit since 2001.

All times are GMT -5. The time now is 04:41 AM.

Page 4 of 4

« First

Show 40 post(s) from this thread on one page