B1 Drive does not go all the way down
01-08-2012, 05:38 PM
#1
Registered
Thread Starter
Join Date: Sep 2005
Location: Warwick, Bermuda
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
B1 Drive does not go all the way down
Having Problems with my Bravo Drive.. It goes all the way up with no problem, and shuts off once it gets to the stop point, but when i try to bring it down, it goes about 1/2 way down, but does not shut off, so if i press on the trim switchs, it sounds as if, it's still engaged but not moving.. i just noticed it this past weekend.. does it sould like it has air in the lines.. i was also by myself, so i was hopping in and out of boat, so it could just b me..lol, i have an electrical trim sender that does not work either..:-( but i'm looking to go with the stainless marine mechanical one...Any suggestions
Thks Q
Thks Q
01-08-2012, 05:52 PM
#2
Registered
iTrader: (5)
Good donkey punch always worked when my ex wouldn't go all the way down....
Seriously though could be a sticking ram or valve in the pump best bet is get someone to give you a hand and diag a little further maybe try flushing the fluid out of the lines
Seriously though could be a sticking ram or valve in the pump best bet is get someone to give you a hand and diag a little further maybe try flushing the fluid out of the lines
