msd coil compatible with stock system need help
#1
Registered
Thread Starter
Join Date: May 2010
Location: tn
Posts: 265
Likes: 0
Received 0 Likes
on
0 Posts
msd coil compatible with stock system need help
burning up ign module sensors inside the distributor.
called msd they said and alot of you said it might not be compatible with the stock mercury thunderbolt iv ign
MSD needs to know what ohms my stock coil is suppose to be at then they said they will know if there msd high vibration coil will work.
does anyone know what a stock coil on a 454 330hp motor should ohm out at?? thanks
called msd they said and alot of you said it might not be compatible with the stock mercury thunderbolt iv ign
MSD needs to know what ohms my stock coil is suppose to be at then they said they will know if there msd high vibration coil will work.
does anyone know what a stock coil on a 454 330hp motor should ohm out at?? thanks
#3
Registered
You may need a ballist resistor in the line. I tried A blaster coil with a points dist. without a resistor and the points lasted about a minute before they turned blue and pitted.
#6
Charter Member # 55
Charter Member
Why not just get a Merc coil and be done with it???? I had an MSD coil go bad after 2 years on my Pantera. I put a 10 year old Merc coil on it and it was still working fine.