the distrubator and coil,moduel and pickup coil is new the distrubator sparks on the bench test , their is power to the red wire at the coil but no spark, key switch purple wire has 12 volts when cranking and the yellow/red strip wire has power to the starter when cranking but still no spark, the purple wire that goes into the ECM has no power and when i put 12 volts to that wire still no spark , anyone have anymore ideas, im running out of ideas, also did allthe grounds again all sensors are conected and good , no kill switch on this motor and no crank sensor , before the problem with the VST tank motor the engine ran good

The manual #16 has a great flow chart for this. Might be able to find it oline.

does the little center piece in the center of the Dist cap need to proturde down from the cap , mine is flush with the cap and looks sheared off flush with the cap >?

you should have a fuse and relay for the ecm,,,check fuses and swith relay with another one

You will need the flow chart:

http://www.boatfix.com/merc/Bullet/83/83_24.pdf

and the wiring diagram:

http://www.boatfix.com/merc/Servmanl/16/16F4R2.PDF

This troubleshooting is very strait forward.

make sure you have good clean tight ground also.

Thank guys will try these things tomorrow ill keep posted

Absolutely it needs to stick down and some are spring loaded. If it seems broken it probably is and sparks could fly all over inside the cap and not make it to the plugs. Check spark by plugging a spark plug into the coil wire running to the cap, ground it with a jumper and see if you get a good consistent spark..

cool thankyoiu ill give it a try

i had the boat running fine but it only lasted about five mins then quit and back to no spark again