Mercury efi to holley efi. How to get the correct throttle throw.

Reply Subscribe

Thread Tools

07-27-2014, 02:38 PM

#11

indysupra

Registered

Thread Starter

iTrader: (3)

Join Date: Jul 2012

Location: indianapolis

Posts: 1,248

Likes: 0

Received 2 Likes on 2 Posts

Quote:

Originally Posted by indysupra

Shifters don't have other throws on them , that was my first guess. Don't have a pic but my current setup is this adapter on the t/b. Yes 1000cfm
http://www.michiganmotorz.com/thrott...FZTm7AodxnIAug

Throttles don't have other throws. I'm going to machine some longer arms for the throttle body's and raise the cable mounting points. I just figured there was a kit I could buy. I don't want to spend $1000 on new shifters/throttles either.

07-27-2014, 08:30 PM

#12

onesickpantera

Registered

iTrader: (1)

Join Date: Feb 2005

Location: Michigan

Posts: 4,388

Likes: 40

Received 21 Likes on 10 Posts

I made an aluminum extension so the cable hooked farther from the pivot. I then used spacers to raise the cable mounting so there wasn't a drastic angle. Had about $5 into the whole set up. I'll look for a pic.

07-28-2014, 05:23 PM

#13

indysupra

Registered

Thread Starter

iTrader: (3)

Join Date: Jul 2012

Location: indianapolis

Posts: 1,248

Likes: 0

Received 2 Likes on 2 Posts

That's my plan. Thanks.

07-31-2014, 07:48 AM

#14

onesickpantera

Registered

iTrader: (1)

Join Date: Feb 2005

Location: Michigan

Posts: 4,388

Likes: 40

Received 21 Likes on 10 Posts

This is all I did. Simply bent some flat stock for the extension and then got some spacers and longer bolts at Home Depot for the mounting. This was supposed to be temporary but I never got around to making it "prettier".