EFI intake
 

I am looking for an intake manifold that is going on a 598 , 10.2 deck.
planning for approx. 1000 HP
I am looking for one with a monoblade throttle on the front instead of on top.
The reason for this is I plan on installing a Procharger in a few years and don't like the looks of the hat on top.
I know I can get a sheet metal one made but was looking for one that is cast.
I saw a picture of one but can't find the maker.
Thanks
Steve

What about a single plane with a Wilson elbow and throttle body

Also check out
http://www.6061.com
They have about every type of badass sheet metal elbow you could think of.

Sounds like an amazing setup! I researched doing the same in unleashed since I Loved my prochargers on the last boat.

Check out http://www.stevemorrisengines.com/, They have some parts you might like.

This blue engine under the 700-1900hp From Lightning performance group has to be one of the sexiest I have seen in a while!

http://www.kustomboltons.com/custom-...g-engines.html

weather you like the look about them or not keep in mind on dyno test the 4 barrel type throttle body produced much more power than the forward round style...

there was a guy a few months back that had some orange ones for sale, Id not seen any like them before, they were a tunnel ram style, I think they were for a 10.2 deck, with large mono blade TB, cant find the post

Maybe you could go with the new Edelbrock or Profiler tunnel ram and get someone like Wilson or Hogan to make a front entry top.

I made over 1000rwhp @ 18psi on my turbo car with a victor Jr single plane Wilson elbow and Wilson 101mm throttlebody

we made in the neighborhood of 950hp w/ a 540 and a super heavily ported hp500 set up and vortech.enough to push a 38' formula fastech to 110mph from rolling 30mph,,in about 1mile.its the 1 w/ arnesons.