PSE superchargers
#3
Registered
Platinum Member
Thread Starter
Join Date: Jan 2006
Location: wisconsin
Posts: 688
Likes: 0
Received 0 Likes
on
0 Posts
Yes Joe, its the second guy.Just wondering if anyone used him on marine super chargers. Mainly the 850, 1075, 1200 stuff. Before I post In the beware section, I just wanted to see if anyone had good luck with them. Or bad luck for that matter.
#5
Registered
Platinum Member
Thread Starter
Join Date: Jan 2006
Location: wisconsin
Posts: 688
Likes: 0
Received 0 Likes
on
0 Posts
Well, long story short he was sent 4 super chargers off a twin Merc 850SCI boat. Only one supercharger was bad (timing slipped & screws lightly touched), so what the heck send them all in to get checked. The guy charges rush fees, and total to fix is more then new ones WTF??? Ok whatever right? well they don't last 10 minutes, and thats only Idle and up to 3500 RPM max. Now all 4 are junk. He gets called and he says to send them back he will take care of it. Ya right... he then admits to putting car screws in them instead of the marine spec'd screws. He charges to fix them again with the original rotors & holds them ransom until payment is taken care of. He points fingers at Merc racing and everyone else involved but his own company. This even after admitting to putting the wrong parts in them.
#10
Registered
Platinum Member
Thread Starter
Join Date: Jan 2006
Location: wisconsin
Posts: 688
Likes: 0
Received 0 Likes
on
0 Posts