What did you rebuild with? I'm thinking going Johnson. Everyone I've talked too recommended them.

Isky, Crower, and Teague , amongs others, have gone here. http://johnsonlifters.com/Distributors.aspx

Check out full listing under the map.

Hopefully we get more feedback as time goes on.

I just put in new Johnson lifters along with a new cam. Lifters were stock spec replacement for the GM lifters and cam is a crane 741. 3/4 turn after zero lash. No issues as of yet. Hope you get this solved sooner than later.

Pretend you weren't on this thread.

Thanks. Paying someone to re-do everything. Sweet. The lifter company isn't paying for any labor. Shocker.

They going to reimburse you for the lifters? Btw keep us informed on what you end up with as well as the outcome.

Good luck and sorry for your troubles.

What are you going with for lifters this time?

Threads like these make me want to go solid roller next time.

Yep, spent $8000 for top end rebuilds only to spend another likely $3000 to get it fixed. So fuggin pissed

My like above is actually I understand and right with you. Been in these situations a couple too many times.

Every year I had wished GM would make a bad azz HR lifter for the BBC's like they do for the sbc. Cherry on top is the GM SBC lifters are cheap.