No s#it! My Shotguns never looked bad. My Gaffrig switchables are terrible. I'm putting CMI switchables on my AT and hopefully they are better. A lot of my friends run the CMI's and their maintenance is minimum. Is there something you can put on them? I thought there was a thread on some protectant, shark skin or something?

I would think running dry exhaust not enough water is getting on them and also if it is dry exhaust you are running, due to a large cam, I would leave them off and be more afraid of water reversion than noise. my 2 cents

Drew gave me a call and stated the fix is relatively simple. Remove the shotguns and drill an 1/8" hole going into the water jacket of the pipes. I did it already and hopefully test this weekend. I"ll let you guys know the outcome

Good customer Service! Let us know how it works.

Padraig

Went out today and Drew's fix corrected I would say 75% of problem. I used the lime away at the ramp and gave a two minute buff with Blue Magic and life is all good!!
Instead of a few hours buffing like last time, I only spent 5 minutes.