Fuel Tank pickups
10-22-2002 | 10:12 AM
#2
Official OSO boat whore
Joined: Oct 2000
Posts: 6,157
Likes: 0
From: Mequon, WI
Mine are just a piece of aluminum tubing with a 45 degree angle cut on the end. The other end of the tubing is tapped and is threaded into a reducing bushing. This bushing is then threaded into the tank bung.
10-22-2002 | 05:50 PM
#3
Registered
Joined: May 2001
Posts: 1,673
Likes: 1
From: Lake Lanier, GA
I just made some for my boat. Welded new bungs into the top of the tank, then took some 5/8" I.D. stainless tubing, and welded it into a 3/4" N.P.T. by -12 A.N. adapter. Not too bad of a job while the motor is out.
Doug
Doug
