|
Water dumps
I have a warlock 25 sxt with a carb 502.i have to much water presure.I put 2 dumps off the rear of the intake with values to controll the flow but the motor dosnt get enough water to the thermostate.where is the best place to put my dumps.Thanks.
|
Put an adjustable pressure relief valve in the main water supply hose.
|
Here’s what you need. https://cimg7.ibsrv.net/gimg/www.off...51203a671.jpeg |
Wher did you get them and where do you install them at.
|
Hardin Marine or CP Performance. I prefer to put them in the hose that goes from the oil cooler to the motor so you get full flow through the oil cooler.
|
Originally Posted by payuppsucker
(Post 4639543)
Hardin Marine or CP Performance. I prefer to put them in the hose that goes from the oil cooler to the motor so you get full flow through the oil cooler.
Merc racing suggests to put there's and all water psi regulators after the oil cooler but before the block.. |
I put mine before the oil cooler, but I’ve never dumped any water. Mine runs at around 12PSI |
Originally Posted by warlocky
(Post 4639431)
I have a warlock 25 sxt with a carb 502.i have to much water presure.I put 2 dumps off the rear of the intake with values to controll the flow but the motor dosnt get enough water to the thermostate.where is the best place to put my dumps.Thanks.
|
Originally Posted by vintage chromoly
(Post 4639554)
I put mine before the oil cooler, but I’ve never dumped any water. Mine runs at around 12PSI |
Originally Posted by payuppsucker
(Post 4639564)
You are obviously not running a thermostat.....correct? |
| All times are GMT -5. The time now is 10:43 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.