Trim limit adjustment

Reply Subscribe

Thread Tools

08-19-2018 | 10:02 AM

Force265

Thread Starter

Registered

Joined: May 2017

Posts: 30

Likes: 0

From: Northern ohio

Trim limit adjustment

Bravo 1. Am I’m missing something? Drive down and marks aligned then position sending unit on full clockwise. Now do I need someone holding drive button up then tun counterclockwise to desired length? Then lock it down And is it 20 3/4 or 21 3/4

thank you!

08-19-2018 | 10:09 AM

BUP

Banned

Joined: Jul 2011

Posts: 9,594

Likes: 45

From: Ft. Worth TX

Bravo = 21 - 3/4 ram center pin to pin
Alpha gen 1 the same

Alpha gen 2 = 20 - 3/4

All trim adjustments and limit adjustments are in the Bravo service manuals.

08-19-2018 | 10:53 AM

Force265

Thread Starter

Registered

Joined: May 2017

Posts: 30

Likes: 0

From: Northern ohio

So I’m turned completely clockwise and I’m at 24 pin to pin. I can’t turn counterclockwise or it goes higher. I’m pretty sure I aligned marks before placing?

08-19-2018 | 01:46 PM

AllDodge

Registered

Joined: Nov 2009

Posts: 4,198

Likes: 500

From: KY

Lower the drive, align the marks then raise it till it stops. If its to high, lower the drive some, rotate the switch a little and raise the drive again. If it got worst, lower the drive and rotate the switch the other way, then raise again. Repeat until it meets the spec or is a tad less, just not over