Offshoreonly.com - 502 rebuild

Page 7 of 10

« First

Last »

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - 502 rebuild (https://www.offshoreonly.com/forums/general-q/357232-502-rebuild.html)

Crude Intentions

02-24-2019 02:21 PM

Yes. Leave center open and plug side one. Just like the pic above.

TomZ	02-25-2019 02:30 PM

Following.

92Cole

02-25-2019 10:56 PM

Thanks again will post some pics soon ��

92Cole

05-12-2019 02:36 PM

Connecting rods clearances

looking for connecting rod side clearances for bbc

TomZ	05-12-2019 03:07 PM

A clearance of .015 would be the minimum I’d use. I think my last one was set up at .020. Too tight is bad.

92Cole

05-15-2019 11:12 AM

Quote:

Originally Posted by TomZ (Post 4686583)

A clearance of .015 would be the minimum I’d use. I think my last one was set up at .020. Too tight is bad.

had 0.24 clearances 👍🏻

92Cole

05-15-2019 11:15 AM

https://cimg2.ibsrv.net/gimg/www.off...23e354d6b.jpeg
It’s starting to come together thanks for all the help and advice guys 👍🏻

92Cole

05-15-2019 11:17 AM

Any tips on figuring out head gasket thickness. Bought comp piston tool and degree wheel set.

Baja Rooster

05-15-2019 12:49 PM

Quote:

Originally Posted by 92Cole (Post 4687006)

Any tips on figuring out head gasket thickness. Bought comp piston tool and degree wheel set.

Figuring out how deep the piston is in the hole and head chamber volume is a good start. .039 is typical and adjust as needed to keep quench below .050 or so.

92Cole

07-05-2019 06:05 PM

https://cimg0.ibsrv.net/gimg/www.off...f0c269587.jpeg
Water jackets are not matching up trying to figure out if AFR sent me wrong heads. Parts number is for a gen6
https://cimg1.ibsrv.net/gimg/www.off...a1ea26147.jpeg

All times are GMT -5. The time now is 07:08 AM.

Page 7 of 10

« First

Last »

Show 40 post(s) from this thread on one page