572 blower cam
#12
Registered
Thread Starter
Join Date: May 2010
Location: Cedar Springs MI
Posts: 574
Likes: 0
Received 0 Likes
on
0 Posts
#13
Registered
iTrader: (7)
I nearly worded it the same as you regarding not giving two chits or thinking twice while in the boat. You'll be fine and look forward to coming down. Not on FB. One thing I tend to stay away from. Looking forward to selling out so I have more time for this never ending hobby. Can't wait to see that monster on the dyno and listen to it grunt. Back in the day we'd spend late nights out there. Some before they had to muffle outside. Talk about some wicked sounding pulls. I'll pm you my ph number.
#14
Registered
iTrader: (3)
my whippled 588s have hyd roller cams 262/[email protected] with 650 lift,easy on the valve train and north of 1200 hp and 1100 ft pounds of torque.imo your heads are too small for 572 inch engine and will loose some higher rpm hp.
#15
Registered
Thread Starter
Join Date: May 2010
Location: Cedar Springs MI
Posts: 574
Likes: 0
Received 0 Likes
on
0 Posts
my whippled 588s have hyd roller cams 262/[email protected] with 650 lift,easy on the valve train and north of 1200 hp and 1100 ft pounds of torque.imo your heads are too small for 572 inch engine and will loose some higher rpm hp.
#16
Registered
iTrader: (7)
Mike was that a custom grind? Power plant.
#17
Registered
Thread Starter
Join Date: May 2010
Location: Cedar Springs MI
Posts: 574
Likes: 0
Received 0 Likes
on
0 Posts
I can only imagine. You'll be fine. You mentioned chamber CC's but not intake runner CC's. If I had to guess I would say around 340 or so with the flow numbers you posted. Your cam will work well with heads at the rpm I would imagine you'd like to run at WOT. (Under 6k). I see do see where mike is coming from but... I'm trying to think back if it was smitty that did a 548 build or there close to it with a 315 head and made near 1,000 hp. Have to do a search, it was a few years back.
Mike was that a custom grind? Power plant.
#20
Registered
Thread Starter
Join Date: May 2010
Location: Cedar Springs MI
Posts: 574
Likes: 0
Received 0 Likes
on
0 Posts
my whippled 588s have hyd roller cams 262/[email protected] with 650 lift,easy on the valve train and north of 1200 hp and 1100 ft pounds of torque.imo your heads are too small for 572 inch engine and will loose some higher rpm hp.