Dan, In the Load Sensing box, do you run in Speed Density or VE mode?
Thanks

if you have a MAF,mass airflow sensor,you can run ve,if you only have a MAP sensor,its speed density,I always use speed density.

Installed V5 tonight. Sent my custom global file to the ECU, configured my sensors, and set the dual sync distributor at 50° BTDC.
All recognized and working. Now just waiting on the coil harnesses. I'll hook up the fuel pump and relays tomorrow and check for fuel leaks.

Damn, at the rate your going we"ll be dynoing that biotch here REAL soon! is anything else holding you up?

What feeds the MPH gauge?

You can use any 0-5 voltage GPS speed sensor. I'm sure this would work.
https://www.autometer.com/universal-...tate=pg:2/ct:q

Not really. Not paying attention I ordered the harnesses that ICDEDPPL posted on his receipt. Not knowing that my D585 coils used a different coil plug. LS Harness not IGN1A harnesses. They should be here this week.
2 558-312 harnesses for sale! lol $125ea shipped. https://www.holley.com/products/igni.../parts/558-312

I wonder if those harnesses will plug into a holley terminator X, I think these valve covers I bought need IGN1A coils (or D580's) (the mounting), If so, Ill take the coil harnesses for my E-85 motors Im building for the scarab

Running E85 I'd probably run the IGN1A coils.

13-1 548 your probably right