Go Back  Offshoreonly.com > Technical > General Q & A
Bravo 1x top cap >

Bravo 1x top cap

Notices

Bravo 1x top cap

Old 05-19-2021, 02:18 PM
  #1  
Registered
Thread Starter
 
Join Date: May 2021
Location: Atlanta
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default Bravo 1x top cap

Hi all,
i purchased a drive shower and when removing the top caps 4 bolts, the cap raised up slightly allowing gear oil to spill down the drive. I installed the shower and spacers and the new bolts and torqued the bolts to 25 ft lbs. question is, Do I need to replace the large and small O rings because the cap seal was breached?
This is on a Bravo 1 x drive.
Thanks!
Neil
marauder9 is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.