|
Originally Posted by Mbam
(Post 4853745)
Yes
|
Yes
|
Originally Posted by Mbam
(Post 4853748)
Yes
great thank you so much |
Originally Posted by Mbam
(Post 4853737)
I can't find the drawing for the disc. Just measure the ID of the bell housing. Also I can't remember what that 5" long section of the tool is for. I don't think it has to be there.
Hopefully you can find someone to make the tool for you quickly. Mercury doesn't really have a tool for the M6/NXT so the instructions are out of an old shop manual (which is where I got the idea in the first place) it seems there is a step up https://cimg1.ibsrv.net/gimg/www.off...0a28a1c61.jpeg |
If his cad drawing is correct to scale it looks like 2" OD
|
https://www.hardin-marine.com/p-6217...899898t05.aspx
this is the one I bought for 6’s |
I'm pretty sure that part of the drawing is a mistake. I will verify when I get to the shop later in the week.. When I made that Mercury didn't have a tool.
That Mercury part number looks like it will do the job. There are 6 pieces at the factory. I'm sure it's less expensive to buy that one. We are closed until Jan 3 so you can get it faster from another dealer. |
Originally Posted by Mbam
(Post 4853737)
I can't find the drawing for the disc. Just measure the ID of the bell housing. Also I can't remember what that 5" long section of the tool is for. I don't think it has to be there.
Hopefully you can find someone to make the tool for you quickly. Mercury doesn't really have a tool for the M6/NXT so the instructions are out of an old shop manual (which is where I got the idea in the first place) |
| All times are GMT -5. The time now is 05:35 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.