Go Back  Offshoreonly.com > Technical > General Q & A
Cooling system upgrade questions >

Cooling system upgrade questions

Notices

Cooling system upgrade questions

Old 01-09-2023, 07:48 AM
  #11  
Registered
 
Join Date: Apr 2007
Location: Ontario
Posts: 583
Received 77 Likes on 38 Posts
Default

Originally Posted by BBYSTWY
Thanks for the advice! I think I will be ok with the increased volume as I never see anything on my pressure gauges unless I'm moving and I have dumps on the back of the intake with no stat or circ pump just wide open. Would it benefit me at all to run a say -4 an into the chiller to get some kind of flow through it for long idle periods or just leave it alone? Thanks again!!
wouldn't hurt anything to tee a -4 off of your bell housing cooler to the chiller..
bigfarmer is offline  
Old 01-09-2023, 08:01 AM
  #12  
VIP Member
VIP Member
Thread Starter
 
BBYSTWY's Avatar
 
Join Date: Jul 2017
Location: Sodus MI
Posts: 1,649
Received 248 Likes on 124 Posts
Default

Considering that would essentially tie the 2 independent systems together, the dual sea water pump engine cooling side and the no pump intercooler side, should I put some kind of check valve in the -4 tee so I don't get bleed back from the cooler circuit or do you think pump pressure will always exceed non pump pressure through the cooler? Just don't want to cause any interference issues. Thanks bud!
BBYSTWY is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.