|
Someone knows the size of these TB merc 565 is using ?
|
From what I have read I believe they are 80mm throttle bodies.
|
It’s written made in Germany probably bosch .
|
Originally Posted by articfriends
(Post 4876846)
yes, it will take work to get the volute to fit over it, I cut one down w die grinder to get it to fit, the most recent one rookie posted pics of we used mill and rotary table to cut lip down and bored the volute
https://cimg0.ibsrv.net/gimg/www.off...00668def1.jpeg This is the setup that I am running with Holley hp efi and dual sync distributor and smart coils like the 700sci use. https://cimg2.ibsrv.net/gimg/www.off...cb5fee884.jpeg |
What thermostat housing are you using?
|
Originally Posted by Rookie
(Post 4877330)
What thermostat housing are you using?
|
Originally Posted by Rookie
(Post 4877330)
What thermostat housing are you using?
Just divided water outlet from Hardin |
https://www.enginelabs.com/news/test...s-on-the-dyno/
I think TB on the surface of plenum is better . Saw this article this morning |
1 Attachment(s)
Originally Posted by Nosfool
(Post 4877299)
https://cimg7.ibsrv.net/gimg/www.off...0794de0e1.jpeg
https://cimg0.ibsrv.net/gimg/www.off...00668def1.jpeg This is the setup that I am running with Holley hp efi and dual sync distributor and smart coils like the 700sci use. https://cimg2.ibsrv.net/gimg/www.off...cb5fee884.jpeg |
That may be the ticket there to get the clearance for the volute
|
| All times are GMT -5. The time now is 08:34 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.