Hey W aterfoul, My Edelbrock RPM is very close to that. ADV. DUR. 300-306. 240-246@ .050 .560-.573 @ valve 112LC. You say that those specs. pull good out of the hole? That is of primary concern. Other cam I have is Lunati 30218 Adv. Dur. 274-284 [email protected] .540-.550 lift@ valve 112CL. 114LS. Will either of these make this thing a monster out of the hole, or will I need to go smaller?

Remember, hole shots wreck drives!! I don't do hole shots. But, once the bow rolls over if I punch it, it goes!

Damn, I have two cam cards here.... one is older, one is the one that is in the motor now. Not sure which is which! The other one is a 224 intake 232 exhaust.

Mike, we used the 224/232 the last time.

Use The Lunati it will make peak hp @ about 5000rpm and 20-30lb ft more torque between 2500 and 4000 rpm than the edelbrook which make peak hp @ 5500rpm and have less torque then your stock 330hp did under 3000rpm. You can use the stock roller lifters/retainer plate etc with the lunati to as it is under .55 lift

Whiteknuckle,
Did you go with 2.19 / 1.88 valves in your 049 heads?