Recomended way to remove props on Speedmaster's?
#1
Platinum Member
Platinum Member
Thread Starter
Recomended way to remove props on Speedmaster's?
What is the recommended way to remove the props on speedmaster drives? What is the easiest way?
#2
Re: Recomended way to remove props on Speedmaster's?
Usually you can take a hard block of wood and a good heavy hammer and hit the side if the hub. Put the wood flat along the bottom of the blade where it attatches to the hub and hit it. Make sure you thread the nut on a few threads when you do this, they sometimes pop and slide off the prop shaft. If that doesnt work and its really stuck on there, you can try a brass drift or punch and hit the back side of the hub and try to break it loose as well.
Pwrbt33
Offshore Performance
410-827-0200
1-877-GOFAST1
Pwrbt33
Offshore Performance
410-827-0200
1-877-GOFAST1
#3
Gold Member
Gold Member
Join Date: Oct 2002
Location: Fairport,NY
Posts: 747
Likes: 0
Received 0 Likes
on
0 Posts
Re: Recomended way to remove props on Speedmaster's?
I use a length of 4x4 wood between the prop and anti-cavitation plate to break the prop nut loose. I use anti-seize on the splines and have had no problem getting them off. Torque for the prop nut on the #5's is 100 ft lbs according to the manual. There was a thread on this topic a month or two ago. For what it's worth.
#4
Platinum Member
Platinum Member
Thread Starter
Re: Recomended way to remove props on Speedmaster's?
I used a board between the blade and the cavitation plate to get the prop nut loose and then put a block of wood against the base of the blades and gave it a good wack with a hammer and off it poped. Thanks guys.
#5
Re: Recomended way to remove props on Speedmaster's?
Grab the blade with both hands, have a friend remove the prop nut. Carefully strike the prop hub with a heavy duty plastic hammer. Remove the prop.