Intake Part#
02-07-2005 | 07:38 PM
#1
Thread Starter
Registered
Joined: Mar 2004
Posts: 29
Likes: 1
Intake Part#
I took my carb off today and found the chevy part number on my intake manifold. PN 333841 I tried to find the number on the internet but failed. Can anyone help identify this intake? Its on a mark IV 454.
02-07-2005 | 09:34 PM
#6
Registered
Joined: Feb 2003
Posts: 6,192
Likes: 318
From: Lafayette,La
Re: Intake Part#
Originally Posted by Hostile Takeover
Which chevy intake is it? It does not appear to be a high rise. where can I look up old GM part numbers?
no , it's not a high rise. good for low end / midrange . nla from gm. part #'s extinct.
02-07-2005 | 09:45 PM
#7
Thread Starter
Registered
Joined: Mar 2004
Posts: 29
Likes: 1
Re: Intake Part#
Open72, you are a man of much knowledge!
Do you know if it has brass inserts in the water passages? Is it a good manifold. I am doing an upgrade to DANA exhaust manifolds and a roller cam. Would you replace it with a high rise?
Do you know if it has brass inserts in the water passages? Is it a good manifold. I am doing an upgrade to DANA exhaust manifolds and a roller cam. Would you replace it with a high rise?
02-07-2005 | 09:47 PM
#8
Registered
Joined: Feb 2003
Posts: 6,192
Likes: 318
From: Lafayette,La
Re: Intake Part#
Originally Posted by Hostile Takeover
Open72, you are a man of much knowledge!
Do you know if it has brass inserts in the water passages? Is it a good manifold. I am doing an upgrade to DANA exhaust manifolds and a roller cam. Would you replace it with a high rise?
Do you know if it has brass inserts in the water passages? Is it a good manifold. I am doing an upgrade to DANA exhaust manifolds and a roller cam. Would you replace it with a high rise?
ya , it has the inserts. i am actually using the same intake with a 2 inch spacer . going on a 540 with a crane 731 roller. what kinda boat/drive?
Last edited by open87; 02-07-2005 at 09:53 PM.
thanks.
