How fast?? Nordic heat
#21
Registered

Joined: Mar 2008
Posts: 661
Likes: 130
From: pa
don't know if the rage will benefit or not but after reading this i measured my x and came up with 17, its tough to get an accurate reading because of the trailer, i've never experienced blow out coming out of the hole and my boat likes alittle positive trim, just thinking out loud, btw i can't be beat by kevins brothers warlock either!!!
#22
Registered
Joined: Apr 2012
Posts: 1
Likes: 0
àïòåêà: ñèàëèñ êóïèòü àïòåêà, ëåâèòðà öåíà â àïòåêå, ñèàëèñ öåíà, ëåâèòðà ñêîëüêî ñòîèò, ñèàëèñ â íèæíåì íîâãîðîäå, ëåâèòðà ñîôò, ñèàëèñ àïòåêà, âèàãðà ñèàëèñ ëåâèòðà ôîðóì, êóïèòü âèàãðó ñ äîñòàâêîé, ëåâèòðà 20 ìã, ïîñëåäñòâèÿ ñèàëèñ.
#23
#27
Registered
Joined: Jun 2009
Posts: 426
Likes: 0
From: Kirkland, WA
I've been running a 30P 4 blade with a 1.5 spacer and -1 imco lower. Works good not great, torques the boat over pretty hard.
I've since removed the spacer, and just running the -1 lower with a 5 blade 29 hering. Works better, still chine walk but better numbers. Even though I raised it up, the 5 blade makes up for the extra slip.
My prop hub runs 'about' 3ish" below the hull of the boat via straight edge. Little bit of gorilla math involved since I run an extension box.
I'm going to try a -2 in the spring.
I've since removed the spacer, and just running the -1 lower with a 5 blade 29 hering. Works better, still chine walk but better numbers. Even though I raised it up, the 5 blade makes up for the extra slip.
My prop hub runs 'about' 3ish" below the hull of the boat via straight edge. Little bit of gorilla math involved since I run an extension box.
I'm going to try a -2 in the spring.



