Hatch Scoops
02-14-2005 | 03:09 PM
#1
Thread Starter
JC Performance Engines
Joined: Jul 2002
Posts: 8,904
Likes: 33
From: Long Island, NY
Hatch Scoops
I'm not sure if I'll have clearance for the new engine, and I'm looking for ideas of hatch scoops.
Where to get them and what do they look like?
Show me what you got if you got'em.
Where to get them and what do they look like?
Show me what you got if you got'em.
02-14-2005 | 05:47 PM
#3
Registered
Joined: Aug 2001
Posts: 6,337
Likes: 0
From: Edison, NJ, USA
02-14-2005 | 07:34 PM
#4
Thread Starter
JC Performance Engines
Joined: Jul 2002
Posts: 8,904
Likes: 33
From: Long Island, NY
Re: Hatch Scoops
Yea, thats nice, but will it be too overpowering on the 24?
I bet Jo/Pepe can get that.
This is nice too.
I'll have to wait and see how much room i got, before cutting and pasting on my hatch. There is a pad, but it can go.
I bet Jo/Pepe can get that.
This is nice too.
I'll have to wait and see how much room i got, before cutting and pasting on my hatch. There is a pad, but it can go.
02-15-2005 | 12:41 PM
#7
Charter Member
Joined: Jan 2001
Posts: 1,237
Likes: 2
From: south east of dome island
Re: Hatch Scoops
Unless you are adding a roots type blower it should fit. All I did was raise the entire hatch and sunpad 2 1/4 inches. I can fit the Dart intake, 1" spacer and a 3" flame arrestor. If you like the looks of the scoop then by all means do it.
Last edited by IRONMAN; 02-15-2005 at 12:47 PM. Reason: addition
Thread
Thread Starter
Forum
Replies
Last Post
Hot Knots
General Racing Discussion
1
10-25-2008 11:23 PM
