Offshoreonly.com - Search Results

Search: Posts Made By: ksalmine

Showing results 1 to 25 of 105
Search took 0.01 seconds.

Forum: Restorations & Upgrades

04-21-2024, 12:36 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Many different composite works is going in same...

Many different composite works is going in same time, Transom curved few millimeters, so I straighten it up using thickened vinylester and last fairing will be done by sanding thick epoxy primer...

Forum: Restorations & Upgrades

04-14-2024, 11:38 AM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Project going slowly forward, thereis lot of...

Project going slowly forward, thereis lot of glass work, but it's on better side now.

...

Forum: Restorations & Upgrades

04-07-2024, 06:00 AM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

New transom core are glued. It goes well and...

New transom core are glued. It goes well and thickened vinylester resin squeezed out nicely everywhere so bond should be good.
I clamped new core between timber, using many screws through bolt holes...

Forum: Restorations & Upgrades

03-26-2024, 01:42 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

It takes almost a week get motivation to start...

It takes almost a week get motivation to start grinding leftovers down, now its done and 70% surface of bottom is good enough to new lamination.
Transom looks good at first look but it was little...

Forum: Restorations & Upgrades

03-20-2024, 01:35 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

All stringers in engine compartment are off now....

All stringers in engine compartment are off now. Next step is grind all leftovers down and smooth, its ugliest job to do (baddest itch than you can imagine), then all is more nicer to do.
Boat is...

Forum: Restorations & Upgrades

03-08-2024, 03:22 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

It's very nice work in home garage, I can do work...

It's very nice work in home garage, I can do work late night after junior go sleep. By the way I have an avid helper, she is now two years and one month, can do some things already. At least clean...

Forum: Restorations & Upgrades

03-03-2024, 06:07 AM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

https://cimg1.ibsrv.net/gimg/www.offshoreonly.com-...

https://cimg1.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1600x1200/img_20240229_wa0005_77e1c9666097a8ad13ea1071d54849689f5e19f7.jpg...

Forum: Restorations & Upgrades

03-03-2024, 05:48 AM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Boat is in home garage now!!! We did big job...

Boat is in home garage now!!!
We did big job with my friends to get it home. First after four years storage outside air canopy, tires was leaked empty, one had hole in inner tube. Jacking and more...

Forum: Restorations & Upgrades

02-20-2024, 02:05 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

I forgot to show how well engine goes in place....

I forgot to show how well engine goes in place. Drysump pump to notch clearance is nice so engine sit as low as possible in boat. Carbon driveshafts have also clear route from splitbox to drives....

Forum: Restorations & Upgrades

02-20-2024, 02:00 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Two weeks gone after last update and project has...

Two weeks gone after last update and project has gone forward pretty good.
I try new to me manufacturing method, 3D printing. Turbocharger inlet adapter for Scania D16 air filter succeeded well....

Forum: Restorations & Upgrades

02-07-2024, 07:30 AM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Trim cylinders are almost ready. I made few...

Trim cylinders are almost ready. I made few mistakes but all is now repaired. Tubes was 65mm too long, I screwed up lenght dimension from CAD drawing, complete lenght and tube lenght get crossed....

Forum: Restorations & Upgrades

02-03-2024, 12:59 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

I have study metallurgy few weeks and learned...

I have study metallurgy few weeks and learned that we have very best steels available in scandinavia. We have Outokumpu, Uddeholm and SSAB all manufacture very good stuff. Austrian Böhler make maybe...

Forum: Restorations & Upgrades

01-31-2024, 10:28 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

I’m not going to increase flow, vice versa trying...

I’m not going to increase flow, vice versa trying to reduce it like you said. I remove original ZF pump and plug necessary oil channels. Transmission main pressure come now from engine driven...

Forum: Restorations & Upgrades

01-26-2024, 02:12 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

In test run engine run great with turbos and tail...

In test run engine run great with turbos and tail pipes, exhaust gas pressure control work also pretty good.There is few problems, vacuum pump transfer so much air at start that it takes oil with...

Forum: Restorations & Upgrades

01-21-2024, 02:26 AM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Trim cylinder tubes are ready, my friend is...

Trim cylinder tubes are ready, my friend is better welder than me so he stick weld these together. If trim cylinder to drive joint break, everything goes broken. Bronze pushings is now very tight fit...

Forum: Restorations & Upgrades

01-10-2024, 02:08 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

More updates, steering cylinders are ready. ...

More updates, steering cylinders are ready.

https://cimg3.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/1600x1200/img_20240109_175748_1974511cf8955341d344e3dedf44861dc54cf34f.jpg
These are boat...

Forum: Restorations & Upgrades

01-10-2024, 01:38 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

A lot of things have happened after last update....

A lot of things have happened after last update. Let's start of complete engine.
...

Forum: Restorations & Upgrades

12-27-2023, 02:05 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Today I made special heat exchanger. I found 54mm...

Today I made special heat exchanger. I found 54mm and 64mm copper tube and brass R1/4 and 1/2 fittings from local plumbing shop, they convert to three stage oil cooler.
700mm inner tube is one piece...

Forum: Restorations & Upgrades

12-19-2023, 01:41 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

This is twin turbo intercooler simulation with...

This is twin turbo intercooler simulation with more fuel, 15:1 AFR. I think we all are curious of this data:cool: It make 3365hp power, stock heads, stock everything but cam timing. Head flow is...

Forum: Restorations & Upgrades

12-19-2023, 01:05 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

I have run engine in Engine analyzer pro...

I have run engine in Engine analyzer pro software. Results looks pretty impressive but we have to keep mind that this is just simulation. It could be accurate if input information is absolute right....

Forum: Restorations & Upgrades

12-17-2023, 01:03 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

I really don't mind bad if someone try help me, I...

I really don't mind bad if someone try help me, I appreciate that! Actually this thread is made for getting some information, tips and good debate technical things.
I have think about stainless...

Forum: Restorations & Upgrades

12-17-2023, 12:48 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

I live in Valkeakoski, we can make some films...

I live in Valkeakoski, we can make some films after I can transfer Fountain in home garage. it would be nice!

Forum: Restorations & Upgrades

12-17-2023, 05:45 AM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Tailpipes build is nice work to do. I try reduce...

Tailpipes build is nice work to do. I try reduce 5" outer stainless tube and spread 4.5" inner tube, it was success....

Forum: Restorations & Upgrades

12-16-2023, 02:24 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Things are going forward. Turbos are installed,...

Things are going forward. Turbos are installed, charge pipes weld, support bracket is ready and exhaust pipes half ready.
I cut manifold-turbo connector tubes aparts again and lift chargers up 90mm,...

Forum: Restorations & Upgrades

12-08-2023, 12:52 PM

Replies: 326

Fountain 47, 2372cid single engine diesel

Views: 177,284

Posted By ksalmine

Thanks! I don't like powder coating at all. If...

Thanks! I don't like powder coating at all. If water goes under coating it start loose bigger parts. I like epoxy coatings, they don't come of even there is scratch on it. Actually in Finland we have...

Showing results 1 to 25 of 105