Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: 21eagle
Showing results 1 to 25 of 31
Search took 0.07 seconds.
Forum: Swap Shop
08-12-2020, 09:08 AM
Replies: 6
Views: 1,378
Posted By Wally

I had a set of those on my old scarab...i like...

I had a set of those on my old scarab...i like how they mellow out the tone of the motors....if i had room on my boat right now they would be on there as well. :cool:
07-20-2020, 10:27 PM
Replies: 9
Views: 6,514
Posted By mcollinstn

:party-smiley-048:

:party-smiley-048:
07-07-2020, 09:58 AM
Replies: 21
Views: 4,314
Posted By ThisIsLivin

Actually it's a little less. Sorry for the late...

Actually it's a little less. Sorry for the late response I have been out enjoying the good boating weather. Lake Huron has been glass or 6" chop for over a week, that doesn't happen often.
06-28-2020, 09:56 AM
Replies: 6
Views: 1,362
Posted By Craney

Here is a picture of my 28s dash ...

Here is a picture of my 28s dash
https://cimg7.ibsrv.net/gimg/www.offshoreonly.com-vbulletin/2000x1504/fce35764_14ad_416d_925f_79e959081fd4_0f119ba97fdab109af9329cf12fbe3cf48760ff2.jpeg
06-27-2020, 11:35 PM
Replies: 6
Views: 1,362
Posted By 242LS

I did mine over, then the GPS didn’t fit with the...

I did mine over, then the GPS didn’t fit with the steering, so doing it again.

12” Garmin for gauge display using Nolan RS11 A/D converter. Analog gauges on passenger side as backup/extra set of...
06-26-2020, 05:58 AM
Replies: 21
Views: 4,314
Posted By phragle

most people use pumps.......

most people use pumps.......
06-15-2020, 12:08 PM
Replies: 6
Views: 1,037
Posted By zz28zz

Check out this catalog. Lots of good info...

Check out this catalog. Lots of good info including lock-to-lock charts for different helms vs cylinder combos.
https://www.imcomarine.com/nvcatalog/imco_catalog.pdf

Having gone down this road...
06-13-2020, 05:56 AM
Replies: 25
Views: 3,253
Posted By oconnor marine

I think you can remove timing cover and get...

I think you can remove timing cover and get numbers off cam end. Then do a search....
06-11-2020, 10:29 PM
Replies: 25
Views: 3,253
Posted By Baja Rooster

It sounds like someone planned on running hard,...

It sounds like someone planned on running hard, so you can do what the rest of us do - beat it hard until it breaks! If it doesn’t break then you’re golden and if it does then it’s time for bigger...
06-11-2020, 01:35 PM
Replies: 25
Views: 3,253
Posted By Baja Rooster

The Edelbrock Air Gap is a tough manifold to...

The Edelbrock Air Gap is a tough manifold to beat. Check your drive ratio. It’s possible it has the 1.36 gears.
06-11-2020, 12:28 PM
Replies: 12
Views: 2,030
Posted By DiamondPerformance

We sell Seastar Xtreme 3300 series. -...

We sell Seastar Xtreme 3300 series. - https://www.diamondperformanceparts.com/collections/main-menu-collection/control-systems?page=2
06-11-2020, 11:21 AM
Replies: 25
Views: 3,253
Posted By SB

Could be correct for your set up but maybe not....

Could be correct for your set up but maybe not. Try yours and then some others, see what works best. Friends and loaner programs usually cheaper than buying props just to test.
06-11-2020, 10:25 AM
Replies: 25
Views: 3,253
Posted By oconnor marine

i found this quote "24 Pantera TRS mirage 23p...

i found this quote "24 Pantera TRS mirage 23p said to be 400-425hp would flicker 70mph light fuel 1 person. Two people with fuel 68mph was the norm." I think the style would be a mirage plus 14. 5/8...
06-11-2020, 09:10 AM
Replies: 25
Views: 3,253
Posted By SB

Cam and valvesprings has everything to do with...

Cam and valvesprings has everything to do with what engine should / can be rev’d too. And what power potential engine had.

Torquer and Torquer II not a great low/mid/or high rpm intake. Was just a...
06-11-2020, 08:22 AM
Replies: 12
Views: 2,030
Posted By TomZ

For my k-plane indicators I just bought...

For my k-plane indicators I just bought replacements from ebasicpower.com - Seastar Xtreme 3300 series. Prices were less than local by about 15% even with the shipping. Ordered Saturday and had them...
06-10-2020, 01:19 PM
Replies: 17
Views: 5,828
Posted By flashgordon

i have all stainless hoses, but i think the black...

i have all stainless hoses, but i think the black covered stainless hose would be better, still a stainless hose ..
06-10-2020, 10:26 AM
Replies: 17
Views: 5,828
Posted By smashm

Just pulled all 3 motors out of my fountain....

Just pulled all 3 motors out of my fountain. Refinished the whole bilge, replaced EVERY hose with Parker hose from the local Parker store. Made specifically for water intake etc. Same with fuel hose....
06-10-2020, 09:23 AM
Replies: 17
Views: 5,828
Posted By BDiggity

I just replaced what Cigarette originally used. I...

I just replaced what Cigarette originally used. I found a part # & Googled it. Ended up being a Gates Green Stripe hose....
06-09-2020, 05:30 PM
Replies: 17
Views: 5,828
Posted By F-2 Speedy

I miss spoke its Trident

I miss spoke its Trident
06-09-2020, 01:05 PM
Replies: 17
Views: 5,828
Posted By F-2 Speedy

Teledent is pretty flexable

Teledent is pretty flexable
06-09-2020, 12:58 PM
Replies: 17
Views: 5,828
Posted By bigfarmer

I run Black cloth braided hose with zero issues...

I run Black cloth braided hose with zero issues...
06-09-2020, 12:55 PM
Replies: 17
Views: 5,828
Posted By Team Archer

You want to make sure you run a wire reinforced...

You want to make sure you run a wire reinforced marine water hose. Regards Dan P.S. its 1 1/4 inch.
06-01-2020, 09:38 PM
Replies: 4
Views: 775
Posted By speicher lane

care to elaborate? I have no affiliation nor...

care to elaborate? I have no affiliation nor knowledge of the shop... just curious as there is 1600 miles from your shop and most boats are traveling north
06-01-2020, 11:48 AM
Replies: 4
Views: 775
Posted By resurrected

I'm 4 hours the other way. I bought some base...

I'm 4 hours the other way. I bought some base gaskets for my blowers from them a couple of years ago. That's all I have
06-01-2020, 11:45 AM
Replies: 4
Views: 775
Posted By jeff32

4 hours from me! Been in business for... idk 20...

4 hours from me! Been in business for... idk 20 years at least! Not very popular in my area but know one guy who had blower engines built by bullet 15 years ago and was happy with them !
Showing results 1 to 25 of 31
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.