I did not want to use the switch from Gaffrig I did not like the look of the switch or the fact that it would not match anything. I bought a new rocker switch to replace the windshield wiper switch (like I need that) used a label maker for the lettering. I know that sounds crude but it came out o.k.

Try it again

Ray,
This is what I came up with I'm still not sure if I like it but better than what I had. It looks better from up top than a bilge close up but you get the idea.

Looks good Scott, I wish I could reach my cables in order to do the same, I looked at it quite a bit and It is just too hard to get at. I got the polished aluminum Battery holders The look nice, I figured I would get polished so If I want to re-sell them later it would be eaiser than Teal. Also I have polished stainless steel exhaust pipes so it will match them too.

How about some more pictures? I know you must be getting the engines close to done.

My blocks are not ready They better be done today I plan on hauling it to Sandusky tomorrow to install the new motor mounts and allignment. I want to do this with a empty block so we have room to move around in the bilge. Then I will bring it back home and finish the motors. I should be finished in the next couple of weeks

I don't have any new pictures all that I have been doing is re-routing cables and wires plus adding cushion clamps in place of wire ties. I cant believe some of the short cuts taken in the original install. I don't think a wire tied fuel line is exceptable The last many hours have been spent with a buffer Finesse it II and wax. That's a lot of boat even with a buffer