That's the one I ordered...

and if you order direct from GLS it's $25 cheaper!

See, I'll go for the bargin too when I can. LOL!

nice!!!

Guys, I have all the parts now. The table top holes with the nut serts in it line up perfect with the bracket.

Just cut the hole in the floor in the correct spot and I'm good!

Anyone need the piece that goes in the floor? I have an extra that I will sell.

My table top just arrived 2 minutes ago!!!

Now I just need to get to the boat!

Nice! I'm going to grab some nice stainless fasteners this weekend for the table top bracket and the base in the floor.

Quick look and the inserts in table top appear 1/4-20. Have you looked??

Haven't looked yet but I'll get out my thread gauage.

Yes, 1/4 x 20 NC.

Yours installed yet?

My plan is Friday....I'll post pics if I get it done.

No not yet...Don't know when either. I did pick up some stainless hardware though. I got some 1/4x20 srcews that I'm going to cut the heads off of. I'm going to thread them into the table top then use acorn nuts and lock washers to attach the mount. I didn't what hex head bolts with 'sharp' edges and the screws have tapered heads. I still haven't found stainless lag bolts/screws for the floor base. I can only find Robertson head screws so far, #10's I believe.
What are you going to use to seal the cut out in the floor with?

I used bolts for the table top with flat and lock washer.

I have #12 1.5 inch countersunk flat head Philips screw head stainless for the base in the floor. Had to buy 20 so if you need some and can't find them let me know.

I took the base with me and #14 were too big.

I'll post pics how they sit in the base tomorrow.

Awesome...Thnx!