Thrust Bushing needed for Cleaver Prop on TRS
07-15-2005 | 10:36 PM
#12
Thread Starter
Registered
Joined: Nov 2003
Posts: 1,243
Likes: 0
From: Melbourne, FL
Re: Thrust Bushing needed for Cleaver Prop on TRS
I read the TRS Installation manul and it talks about a "continuity washer". I've looked around marina and asked "mechanics" and they don't even know what I'm talking about.
Does anyone on here know about the "continuity washer" ?
In fact the manual also shows a "continuit spring" on the trim cylinder shafts between the rubber bushings. Another "I dunno" from mechs. Dnyone else know about this little device?
Does anyone on here know about the "continuity washer" ?
In fact the manual also shows a "continuit spring" on the trim cylinder shafts between the rubber bushings. Another "I dunno" from mechs. Dnyone else know about this little device?
