Rolla Arneson Cleaver Advice
02-18-2007 | 08:08 PM
#1
Thread Starter
artselectricinc.com
Joined: Dec 2000
Posts: 703
Likes: 27
From: Longview, WA, USA
Rolla Arneson Cleaver Advice
I just installed a used set of 17.5x22 4b Rollas on my 42 Harley with Arnesons.
results: RPMs are 400 too low unless I trim way up
Too much stern lift at high speed.
This is not a speed boat. But I need to get the WOT rpms inline. I gained 2mph on the top end. Props are much smoother than the three blade nibrals that were on it. So I really do like the props, just need to get them adjusted if possible.
Who would be the best person to send these props to?
thanks,
Steve
results: RPMs are 400 too low unless I trim way up
Too much stern lift at high speed.
This is not a speed boat. But I need to get the WOT rpms inline. I gained 2mph on the top end. Props are much smoother than the three blade nibrals that were on it. So I really do like the props, just need to get them adjusted if possible.
Who would be the best person to send these props to?
thanks,
Steve
Last edited by Steve H; 02-19-2007 at 09:44 AM. Reason: clarification
Thread
Thread Starter
Forum
Replies
Last Post
diggerman
General Boating Discussion
3
09-05-2006 02:59 PM
