How does that figure into the gimbal alignment with it being 5" lower?

Drive shaft between engine and inner transom plate must be the answer i guess?

The forward motor is 48 inches farther forward than the rear motor so the drive shaft takes up the angle. the 5 inches is the difference between the heights of the headers on the rear to the front motor.

the dash is getting all redone the owner was out from IL. and finished stripping the dash hardware. It is going to be white gel coat instead f the black padded dash.

Have to start by filling all of the holes 24 small guages and a host of other things.

White will look good

Great job Dan!! You are incredibly fast Without sacrificing quality.

Dash is ready for primer

Nice!!!!!

Owner from IL, will this by chance be an ozarks boat ???

Thats a lot of work. Looking good Dan.