Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: sassea
Showing results 1 to 17 of 17
Search took 0.01 seconds.
Forum: General Q & A
09-11-2010, 04:27 AM
Replies: 12
Views: 2,041
Posted By sassea

Question winter storage ......gas question......

should i add any gas additive to store the boat for the winter????
and should i fill the tank to the top or it doesn't matter?????
Forum: General Q & A
09-08-2010, 05:07 PM
Replies: 6
Views: 3,099
Posted By sassea

can it be an ignition modulator and coil????

can it be an ignition modulator and coil????
Forum: General Q & A
09-08-2010, 05:05 PM
Replies: 4
Views: 1,014
Posted By sassea

is that inline 10 micron fuel fliter located by...

is that inline 10 micron fuel fliter located by the fuel pump itself??????/
Forum: General Q & A
09-08-2010, 02:16 PM
Replies: 4
Views: 1,014
Posted By sassea

454 efi bogs down and dies...............

i was told maybe look at the ignition modular and coil because my engine [after warming up] bogs down and dies after i try giving it some gas.......can this be the problem?????
Forum: General Q & A
09-08-2010, 07:44 AM
Replies: 6
Views: 3,099
Posted By sassea

its an efi.i did change the fuel filter......... ...

its an efi.i did change the fuel filter.........
i dont have access to a pressure gauge...
i do know its "old gas" from 2 seasons ago.its down to 1/4 tank.
Forum: General Q & A
09-08-2010, 07:27 AM
Replies: 6
Views: 3,099
Posted By sassea

454 bogs down and dies......help!!!......

after fully warming up my 454 mercruiser, i put it in gear and it will move slowly but the moment i start to throttle up,it starts to spit out dark exhaust, bogs down and dies.it once in a while will...
Forum: General Q & A
08-21-2010, 02:12 PM
Replies: 2
Views: 886
Posted By sassea

454 over heating....................

i have a 98' 454 mercruiser and was experiencing over heating problems,after back flushing and realising my impeller took a crap on me after finding all cunks of it,, is there any easier way or...
Forum: General Q & A
08-21-2010, 08:10 AM
Replies: 1
Views: 661
Posted By sassea

over heating

i have a 98' 454 mercruser with a bravo-3 out-drive.......
i changed the water pump this season but its now over heating after a couple of trips out.....,,,,
i disconnected the incoming hose to the...
Forum: General Q & A
07-28-2010, 03:01 AM
Replies: 1
Views: 587
Posted By sassea

warm motor boggs down...............

i have a 454 mercruiser in a 25ft formula and upon first taking off, [even on a warmed up engine] the engine bogs down, [almost to a halt]than i have to pull back on the throttle and toy with it a...
Forum: General Q & A
07-28-2010, 02:55 AM
Replies: 0
Views: 649
Posted By sassea

engine hatch actuator help!!!!!

im in desperate need of the old style electric 12" stroke actuator where the motor on it runs perpendicular to the shaft itself....its a very tight spot, and the new style has it where the motor runs...
07-21-2010, 09:30 AM
Replies: 2
Views: 921
Posted By sassea

i need a 12" stroke actuator

can anyone help me in locating an electric 12" stroke actuator that has the motor perpendicular to the shaft for the engine hatch/sun pad???
i have a 98 formula ls and its a very tight spot and cant...
Forum: General Q & A
07-20-2010, 07:57 AM
Replies: 2
Views: 729
Posted By sassea

....thanks for that quick response brian! ...

....thanks for that quick response brian!
should be easy enough to break.........................
Forum: General Q & A
07-20-2010, 07:42 AM
Replies: 2
Views: 729
Posted By sassea

thermostat change-out help needed!!

i have a 454 mercruser .......i want to change the thermostat but im having a hard time removing the old plastic collar from the housing, any tricks or suggestions???????
Forum: Swap Shop
07-19-2010, 03:09 AM
Replies: 0
Views: 522
Posted By sassea

in need of an old model 12" stroke actuator

i have a 1998 25' formula and need the electric engine hatch actuator [ motor and arm]. its the old type with the motor perpendicular to the arm itself,,. the new ones have the motor parallel to the...
Forum: General Q & A
07-18-2010, 04:52 AM
Replies: 5
Views: 1,117
Posted By sassea

thanks for the heads-up, ill try tinmans...

thanks for the heads-up, ill try tinmans suggestion and if i loose my temp guage, ill now know to break it down and wipe off the bead of sealent......thanks guys!!!!
Forum: General Q & A
07-17-2010, 09:13 AM
Replies: 5
Views: 1,117
Posted By sassea

thanks tinman

thanks tinman
Forum: General Q & A
07-17-2010, 04:13 AM
Replies: 5
Views: 1,117
Posted By sassea

thermostat help needed!!!

i have a 454 mercruiser and just changed the thermostat and now i cant get the housing to stop leaking, my question is>>>is that plastic sleeve suppose to be flush to the housing when pushed in or is...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.