Offshoreonly.com - Search Results

Search: Posts Made By: 61vette

Showing results 1 to 7 of 7
Search took 0.00 seconds.

Forum: Drives and Lower Units

05-30-2011, 01:54 PM

Replies: 18

Imco SC won't go all the way in

Views: 3,325

Posted By 61vette

Dick, I though it would be a good idea to put...

Dick,
I though it would be a good idea to put some lube in it.

I did make sure the U-joints were strait, I'm hoping its just the bellows retainer since it comes in the XR Gimbal bearing ...

Forum: Drives and Lower Units

05-28-2011, 02:26 PM

Replies: 18

Imco SC won't go all the way in

Views: 3,325

Posted By 61vette

Yes, I tried it without the O-rings, But as...

Yes,
I tried it without the O-rings, But as i was cleaning up i saw a new Bellows retaining ring in the XR Gimbal bearing Kit, which is about the distance i need to go. Is the a different in the...

Forum: Drives and Lower Units

05-27-2011, 06:14 PM

Replies: 18

Imco SC won't go all the way in

Views: 3,325

Posted By 61vette

OK, Pulled off B1 again; came right off,...

OK,
Pulled off B1 again; came right off, checked engine alignment again and adjusted it very little. replaced O-rings on input shaft and greased them. Rechecked the alignment using grease and...

Forum: Drives and Lower Units

05-23-2011, 07:50 AM

Replies: 18

Imco SC won't go all the way in

Views: 3,325

Posted By 61vette

Thanks for all of your help, going to try on...

Thanks for all of your help, going to try on friday.

Forum: Drives and Lower Units

05-22-2011, 05:24 PM

Replies: 18

Imco SC won't go all the way in

Views: 3,325

Posted By 61vette

Engine alignment is good and i did grease the...

Engine alignment is good and i did grease the shaft and
O-rings. But the O-rings have been on the Shaft since i bought
the drive last year, they are new but been on the shaft in the box for 9...

Forum: Drives and Lower Units

05-22-2011, 04:01 PM

Replies: 18

Imco SC won't go all the way in

Views: 3,325

Posted By 61vette

The Imco drive stops just before it touches the...

The Imco drive stops just before it touches the treads, i've
pulled out the drive made sure the U-joints were lined up and
the shift cable was lineup and then had a friend help the second time,...

Forum: Drives and Lower Units

05-22-2011, 03:04 PM

Replies: 18

Imco SC won't go all the way in

Views: 3,325

Posted By 61vette

Imco SC won't go all the way in

Help,

Freshened up the motor this winter and installed the new
XR red dot gimbal bearing. Engine alignment seams good. alignment tools goes in easy and the grease marks look good. the new...

Showing results 1 to 7 of 7