Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: miwettig
Showing results 1 to 25 of 39
Search took 0.00 seconds.
Forum: General Q & A
08-15-2013, 02:50 PM
Replies: 7
Views: 2,488
Posted By miwettig

2 Beeps at startup then stop?

496 Ho's. Still working on My 2 beeps/min issue. Replaced the sea water psi sender and now get beeps at startup but they stop after that. Boat running on muffs on a rack. Also getting 152 code,...
Forum: General Q & A
08-08-2013, 08:36 AM
Replies: 5
Views: 825
Posted By miwettig

Mine are 2005. Part no.8M600023 is on the power...

Mine are 2005. Part no.8M600023 is on the power steering cooler. Is that it? Is it looking at a 'blockage' or something to do with the block?
Forum: General Q & A
08-07-2013, 09:57 PM
Replies: 5
Views: 825
Posted By miwettig

I replaced both sea pumps this year don't recall...

I replaced both sea pumps this year don't recall any sensors unless it's the small hose on top?
Forum: General Q & A
08-07-2013, 04:29 PM
Replies: 5
Views: 825
Posted By miwettig

Block Pressure zero?

Trying to find 2beeps/sec problem. 496 HO. Scan shows pitot active. I understand this is normal? Scrolling thru data shows block press zero. Is this normal? What should the range be? Where is the...
Forum: Powerquest
08-03-2013, 11:45 AM
Replies: 8
Views: 1,194
Posted By miwettig

Are these vents removable from the outside for...

Are these vents removable from the outside for cleaning?
Forum: Powerquest
08-01-2013, 03:43 PM
Replies: 8
Views: 1,194
Posted By miwettig

Gas filling issues 300 Rev?

300 Revenge fill line backs up on occasion but not every time. Change the angle of the hose, no improvement. Some days no problem. Haven't checked the vent yet..just odd it is intermittent?
Forum: Powerquest
07-27-2012, 03:50 PM
Replies: 15
Views: 2,493
Posted By miwettig

I'm getting 76mph w/28" props and HO's...

I'm getting 76mph w/28" props and HO's stock...does that sound right??
Forum: General Q & A
07-18-2012, 02:49 PM
Replies: 21
Views: 3,154
Posted By miwettig

Thanks for the test results. What boat, length...

Thanks for the test results. What boat, length and motor?
Forum: General Q & A
07-18-2012, 12:22 PM
Replies: 21
Views: 3,154
Posted By miwettig

Mercury recommends dropping down 2" if going from...

Mercury recommends dropping down 2" if going from Bravo I to the Maximus 5 blade...agree or disagree?
Forum: General Q & A
07-17-2012, 03:03 PM
Replies: 21
Views: 3,154
Posted By miwettig

Are Hydro's still available?

Are Hydro's still available?
Forum: General Q & A
07-16-2012, 03:35 PM
Replies: 21
Views: 3,154
Posted By miwettig

keep me in the loop w/your results. How do work...

keep me in the loop w/your results. How do work 'slip' numbers?
Forum: General Q & A
07-16-2012, 03:00 PM
Replies: 21
Views: 3,154
Posted By miwettig

going to 5 blades cost you a drive??

going to 5 blades cost you a drive??
Forum: General Q & A
07-16-2012, 02:47 PM
Replies: 21
Views: 3,154
Posted By miwettig

Maximus?

Maximus?
Forum: General Q & A
07-16-2012, 06:49 AM
Replies: 21
Views: 3,154
Posted By miwettig

Should I go w/stock 5's for everyday and have the...

Should I go w/stock 5's for everyday and have the 4's I have now labbed for special days or go 5 labbed for everyday?
Forum: General Q & A
07-16-2012, 06:25 AM
Replies: 21
Views: 3,154
Posted By miwettig

5 blade for midrange performance?

I spoke w/Cutting Edge props in California about maximizing mid range performance on my 30' w/mag HO's and his recommendation was to use a 5 blade, down 1" in pitch and maybe a little tuning to get...
Forum: General Q & A
07-13-2012, 02:03 PM
Replies: 15
Views: 1,835
Posted By miwettig

Greg was recommending his Cutting edge III,...

Greg was recommending his Cutting edge III, rounded tip labbed, 27". Since mid-range is the focus i guess switching from inward turning to outward would be worth trying also.
Forum: General Q & A
07-13-2012, 11:37 AM
Replies: 15
Views: 1,835
Posted By miwettig

Spoke with Cutting Edge. My goal (sorry to say...

Spoke with Cutting Edge. My goal (sorry to say this out loud) is maximizing mid-range performance. His recommendation would be to go to 5-blade, same diameter and drop down 1". Any thoughts?
Forum: General Q & A
07-13-2012, 05:41 AM
Replies: 15
Views: 1,835
Posted By miwettig

thanks guy's. think i'll wait till fall and have...

thanks guy's. think i'll wait till fall and have the 28's labbed.
Forum: General Q & A
07-12-2012, 06:54 PM
Replies: 15
Views: 1,835
Posted By miwettig

My marina said the rule of thumb is 2" on...

My marina said the rule of thumb is 2" on stainless. 496 Mag HO's-7000lbs stepped hull-5000rpm w/28's
Forum: General Q & A
07-12-2012, 05:00 PM
Replies: 15
Views: 1,835
Posted By miwettig

Changing pitch on Bravo?

I want to go from 28" to 30" Local prop shop says they can go 2" either way. Any thoughts?
Forum: Powerquest
07-11-2012, 06:43 PM
Replies: 10
Views: 2,174
Posted By miwettig

Do you get a crossing spray from the tips of the...

Do you get a crossing spray from the tips of the blades breaking the surface with inward turning wheels?
Forum: Powerquest
07-11-2012, 03:19 PM
Replies: 10
Views: 2,174
Posted By miwettig

any links on labbing?

any links on labbing?
Forum: Powerquest
07-11-2012, 03:14 PM
Replies: 3
Views: 939
Posted By miwettig

We're at Sunset Harbor marina on Norman Creek,...

We're at Sunset Harbor marina on Norman Creek, Middle River. I'll send a pic of the boat when I get a good one.
Forum: Powerquest
07-10-2012, 03:35 PM
Replies: 3
Views: 939
Posted By miwettig

We're in Middle River, heading to Herrington...

We're in Middle River, heading to Herrington South this weekend.
Forum: Powerquest
07-10-2012, 03:31 PM
Replies: 10
Views: 2,174
Posted By miwettig

I see 4800 w/28's and Mag HO's. Would like to...

I see 4800 w/28's and Mag HO's. Would like to try 30's but that would take me under 4700 I guess??
Showing results 1 to 25 of 39
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.