Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: bsboss
Showing results 1 to 25 of 167
Search took 0.02 seconds.
Forum: Electronics
03-17-2021, 11:34 AM
Replies: 7
Views: 2,666
Posted By bsboss

Vessel View??

Thinking about updating vessel view race edition to the newer VV903 8M0129544 display only. Beside cutting bigger hole, does the wiring have to be changed?

Thanks
Forum: Swap Shop
08-20-2020, 08:06 PM
Replies: 3
Views: 1,086
Posted By bsboss

yes

yes
Forum: Swap Shop
08-20-2020, 11:45 AM
Replies: 3
Views: 1,086
Posted By bsboss

15 1/4" x 32 5 blade Hill CNC Cleavers

Lh & Rh 5 blade cleavers for sale with 15" Rake. Trued up and balanced by FJ, much better than new! Used only for prop test and too much pitch for my application. Have over 5K in them will sell for...
02-27-2019, 11:48 AM
Replies: 10
Views: 7,395
Posted By bsboss

Trailer Axles should also be aligned, better to...

Trailer Axles should also be aligned, better to align them on trailer with all axles. Harder to find people with knowledge and ability to do a correct alignment. Even new axles need aligned!
Forum: Wanted
05-21-2018, 09:55 AM
Replies: 1
Views: 375
Posted By bsboss

496 Short Block

WTB 496 Short Block
Forum: General Q & A
05-14-2018, 12:00 PM
Replies: 0
Views: 444
Posted By bsboss

496 help?

Posting for friend with 496 with the 525 Raylar kit. No issues until early last year started loosing a little coolant. End of season finally found mechanic willing to check it out and diagnose was a...
03-28-2018, 08:05 PM
Replies: 64
Views: 12,114
Posted By bsboss

Cool We did the same last year, had a good time at the...

We did the same last year, had a good time at the pool! Thought we would run up the lake after the no-wake zone last year, man that was trip! Everybody else waited and was headed down the lake at...
12-08-2017, 09:13 AM
Replies: 7
Views: 1,853
Posted By bsboss

Suggestions on refinishing over anodize?

Looking for suggestions on aluminum jack plates that where anodized black. The boat stored inside through the summer and they turned purple/bronze within 2 months. I have been told can't re-anodize,...
09-28-2017, 11:12 AM
Replies: 55
Views: 16,553
Posted By bsboss

We had similar issue with a local water patrol, ...

We had similar issue with a local water patrol, a few phone calls where made to state representative for that area. Mysteriously she is no longer there after 1 season.
08-29-2017, 10:23 AM
Replies: 31
Views: 13,202
Posted By bsboss

Not sure how the no wake extension really helped?...

Not sure how the no wake extension really helped? Just move the heavy sh** up the lake!
08-15-2017, 12:25 PM
Replies: 9
Views: 1,321
Posted By bsboss

Boat Ramp @ LOTO Shootout

Just curious, people staying at the Camden, where is the best place to put boat in water? Parking trailers?
04-18-2017, 06:44 PM
Replies: 45
Views: 14,300
Posted By bsboss

Something to think about? I quit using the lead...

Something to think about? I quit using the lead acid batteries in my boat, do to 1 exploding! Caused a huge mess to clean up! It was on a very good (top of the line) on-board charger. Probably due to...
Forum: Swap Shop
03-28-2017, 08:12 AM
Replies: 2
Views: 847
Posted By bsboss

Latham Twin Engine Control

Very nice controls out of 2012, $1000 with cables. Black base, 2 short shift, 2 tall throttle with single trim.
Forum: Skater
10-11-2016, 09:15 AM
Replies: 106
Views: 27,993
Posted By bsboss

This is my 1st year running twin outboard and my...

This is my 1st year running twin outboard and my port motor has run a little slower. Also burns more fuel and oil. I thought I had a issue with that motor? Thanks for the post.
Forum: Electronics
08-31-2016, 12:01 PM
Replies: 5
Views: 2,336
Posted By bsboss

Thanks

Thanks
Forum: Electronics
08-30-2016, 05:48 PM
Replies: 5
Views: 2,336
Posted By bsboss

Vessel View Compatibility?

Thinking about a repower this winter, I currently have 2012 Twin Mercury Racing 300XS's and have the Race Edition Vessel View. If I go with the new 400R's, which is DTS, can I still use my Vessel...
08-24-2016, 10:57 AM
Replies: 37
Views: 6,928
Posted By bsboss

Can bigger boats use that one? +30

Can bigger boats use that one? +30
08-24-2016, 09:56 AM
Replies: 37
Views: 6,928
Posted By bsboss

What ramp do you use when you stay @ Camden?

What ramp do you use when you stay @ Camden?
Forum: General Q & A
08-18-2016, 09:58 AM
Replies: 0
Views: 437
Posted By bsboss

Vessl View & DTS

Will the newer DTS work with Vessel View Race Edition. Thinking about repowering and trying to figure what all has to be changed?
08-11-2016, 08:18 PM
Replies: 89
Views: 15,862
Posted By bsboss

OB section would be great, need to include the...

OB section would be great, need to include the Mercury Racing OpitMax too!
Forum: Prop Talk
07-25-2016, 03:11 PM
Replies: 11
Views: 2,071
Posted By bsboss

I ran a 288 w/525 with 28 Bravo 1 @ 5200 rpm. I...

I ran a 288 w/525 with 28 Bravo 1 @ 5200 rpm. I know of another 288 w/525 also ran 28 Bravo 1. My experiences the 288 liked the Bravo 1 the best.
05-17-2016, 03:45 PM
Replies: 36
Views: 24,728
Posted By bsboss

I used to own 2005 25 Outlaw with 496HO. My best...

I used to own 2005 25 Outlaw with 496HO. My best prop was 25 Mirage turning touch under rev limiter. Best speed was 68mph.
04-26-2016, 09:21 AM
Replies: 29
Views: 16,371
Posted By bsboss

Will the labbed prop and bigger taps really help?...

Will the labbed prop and bigger taps really help? Buddy has a 250 Checkmate w/600, porpoise is bad!!! Unless you drive full throttle!! I used to own 25 Baja, w496HO, great boat! My opinion had better...
Forum: General Q & A
03-09-2016, 06:13 PM
Replies: 31
Views: 5,020
Posted By bsboss

Just switched to Odyssey, no more flooded...

Just switched to Odyssey, no more flooded batteries for me!
Forum: Prop Talk
02-23-2016, 02:18 PM
Replies: 1
Views: 853
Posted By bsboss

Mercury SSR hub

Has anybody had 1st hand experience with Mercury Flo-Torq SSR HD Kits? Looking for smoother engaging.
Showing results 1 to 25 of 167
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.